Panasonic AJ-FX216 Operating Instructions Manual

Contents

-23-Sensor 16 Sensor 1BuzzerNOCNCTo BuzzerRelay+24VNC: Normally Closed ContactNO: Normally Open ContactC: Common• Connection with the Alarm SensorYou can connect an alarm sensor to record the pic-tures of channels that receive alarm input signal.Use an alarm sensor that meets the following con-ditions:1. The power capacity must be less than 5 V DC(open collector output or normally open con-tact).2. The voltage between the alarm connector andthe ground terminal must be 0-0.8 V when con-tact is made.Connect the sensor switch and the alarm input con-nector.Note:Leave connector pin 23 blank.• Connection with the Alarm Output ConnectorPower capacity of alarm output connector less than100 mA:• Make sure to match the polarity when connect-ing the buzzer to the alarm output connector.• Connect the positive pole (+) of the buzzer topin 24 of the alarm output connector.Power capacity of alarm output connector morethan 100 mA:• Connect the buzzer through a relay circuit topin 24 of the alarm output connector. Do notconnect it directly.