16OperationCheck that the SERVO lamp remains lighted duringrecording. When it flashes or it is off, the playbackimages will be disrupted.This function can be used only when the AJ-YA120AG(optional accessory) has been installed.RecordingPause/recording(follow-on recording)Press the PAUSE/STILL button while thecassette tape is playing back.1Press the REC button to set the unit to theREC PAUSE mode.The monitor display now switches to the E-Escreen.When REC-P or ALL has been selected as themenu item No.154 [AUTO BACK] setting, thetape will be rewound for several seconds fromthe position where the PAUSE/STILL button waspressed.2Press the PAUSE/STILL button to startrecording.The tape now runs as far as the position wherethe PAUSE/STILL button was pressed in step 1,and recording commences.The E-E screen is now displayed.3Press the PAUSE/STILL button again totemporarily stop the recording.When REC-P or ALL has been selected as themenu item No.154 [AUTO BACK] setting, thetape will be rewound for several seconds fromthe position where the PAUSE/STILL button waspressed, and then it will stop temporarily.4Follow-on recording can be performed byrepeating steps 3 and 4.5Set the cassette tape’s erasure prevention tabto recording enable, and insert the tape.11. Selecting the input audio signals1) Connect the signals to be recorded.2) Use menu item No.700 [AUDIO IN SEL] toselect the audio input signals.When “1394” is selected as the menu itemNo.600 [VIDEO IN SEL] setting, the audiosignals are input from the DV connector (digitalvideo interface) regardless of the AUDIO INSEL setting.2. Adjusting the analog audio levelsO Adjust the levels of the audio input signalswhen analog audio signals have beenselected as the audio input signals.When the audio recording level controls areat their pushed-in positions, the audiosignals are recorded at the proper levels.When HD SDI signals or signals from the DVconnector (digital video interface) are selectedas the audio input signals, it is not possible toadjust their level.4While holding down the REC button, pressthe PLAY button.The REC and PLAY lamps light, and recordingcommences.When ALL has been selected as the menu itemNo.154 [AUTO BACK] setting, the tape isrewound for several seconds from the positionwhere the REC and PLAY buttons were pressed.The tape will run up, and recording will start fromthe position where the REC and PLAY buttonswere pressed so that the new recording willfollow on from the previous recording with nodisruptions in the continuity of the images.5To end the recording, press the STOP button.Recording now ends, and the unit is set to thestop mode.6Press the STOP button to set the unit to theSTOP mode.2Selecting the input video signalsUse menu item No.600 [VIDEO IN SEL] to selectthe video input signals.3
