25Setup (initial settings)SET–UP MENU 2 NOFACTORYUSER (ALL)USER (NOT SYSTEM)Press the MENU-UP button or MENU-DOWNbutton to move the cursor to the FACTORYposition, and press the SET button.O When the cursor is moved to FACTORY andthis operation is performed, all the settingsexcept the SYSTEM menu settings arereturned to the factory settings.O When the cursor is moved to NO and thisoperation is performed, the display returns tothe menu screen without restoring the factorysettings.4 Press the MENU-UP button or MENU-DOWNbutton to move the cursor to the USER (ALL)position, and press the SET button.O When the cursor is moved to USER (NOTSYSTEM) and this operation is performed, allthe settings except the SYSTEM menusettings are updated.O When the cursor is moved to NO and thisoperation is performed, the display returns tothe menu screen without updating the settings.5Set the LOCAL/MENU/REMOTE switch to theLOCAL or REMOTE position.This completes the menu setting procedure.5Set the LOCAL/MENU/REMOTE switch to theLOCAL or REMOTE position.This completes the menu setting procedure.7SET–UP MENU 2 NOUSER (ALL)USER (NOT SYSTEM)Press the MENU-UP button or MENU-DOWNbutton to move the cursor to the SAVEposition, and press the SET button.The unit is set to the SAVE mode, and the SAVEscreen appears on the video monitor.4SAVE OK?2 NOYESThe screen prompting the user to confirmwhether the settings are to be saved nowappears. To save the settings, press theMENU-UP button or MENU-DOWN button tomove the cursor to the YES position, andpress the SET button.The settings are now stored in the memory.6Setting the user defaultsSet the LOCAL/MENU/REMOTE switch to theMENU position.The unit is set to the menu setting mode, and themenu screen appears on the video monitor.1Perform the operations in steps 2 to 6 for“Setting method using the on-screen menus,”and change to the desired settings.2Press the RESET button.The unit is now set to the default setting mode,and the default setting screen now appears onthe video monitor.3SELECT MODE2 0 ESCAPE1 LOAD2 SAVE3 PROTECTPress the MENU-UP button or MENU-DOWNbutton to move the cursor to the LOADposition, and press the SET button.The unit is set to the LOAD mode, and the LOADscreen appears on the video monitor.3
