Panasonic AJ-HD150 Operating Instructions Manual

Also see for AJ-HD150: Operating instructions

Contents

Panasonic AJ-HD150 Operating Instructions Manual Manual pdf 32 page image

– 32 –Jog/shuttleJog mode 1 Push the search dial to the “in” position.Be sure that the JOG lamp lights.2 Rotate the search dial.The dial’s clickstops are cleared, and the tape is played back at the speed (–1× to +1×normal speed) corresponding to the speed at which the dial is turned. When the dialrotation is stopped, a still picture appears. The playback picture is noise-free.3 To transfer from the jog mode to another mode, press the appropriate button.Shuttle mode 1 Push the search dial to release it from the “in” position. The SHTL lamp lights, and theunit goes into the shuttle mode.• Immediately after the power has been turned on, rotate the search dial and set it to thecenter position.2 Set the SHTL/SLOW switch to SHTL or SLOW.3 Rotate the search dial.When the SHTL/SLOW switch has been set to SHTL, the playback picture speed isvaried from 0 to ±32× normal speed depending on the position of the dial. The playbackpicture speed can be switched to ±8.4×, ±16× and ±32× normal speed with settingmenu No. 101 (SHTL MAX).The dial’s center position is a clickstop where a still picture appears as the playbackimage. When the SHTL/SLOW switch has been set to SLOW, the playback picturespeed is varied from –4.1 to +4.1× normal speed depending on the position of the dial.The maximum speed can be selected using the setup menu No. 308 (VAR FWD MAX)and No. 309 (VAR REV MAX). However, noise appears at speeds other than –1 to +1×normal speed.The dial’s center position is a clickstop where a still picture appears as the playbackimage. The playback picture is noise-free.4 To transfer from the shuttle mode to another mode, press the STOP button or otherbutton.• When the unit leaves the factory, its operation is set up so that it will be transferred to theshuttle or jog mode when the search dial is rotated. If it is inconvenient for operation to betransferred to the variable-speed mode directly, it can also be transferred through thesearch button.Set setup menu No. 100 (SEARCH ENA) to KEY.