Panasonic AJ-HD150 Operating Instructions Manual

Also see for AJ-HD150: Operating instructions

Contents

Panasonic AJ-HD150 Operating Instructions Manual Manual pdf 84 page image

– 84 –Rack mountingThe unit can be mounted into a 19-inch standard rack if the optional rack-mounting adapters(AJ-MA75P) are used. For the installation rails, it is recommended that the rail and bracketfor 18q length (model number CC3061-99-0400) of Chassis Trak be used. If an even greaterclearance is to be left between the VTR and rack when the VTR is pulled out, however, it isrecommended that the 22q long Chassis Trak (model number CC-3001-99-0191) be used.(The complete slide rail and bracket unit is not available from Panasonic.) For further details,consult with your dealer.1 Attach the inner members of the slide rails. Refer to Table 1 for the places where theyare to be secured with the screws.The length of the screws used is subject to restriction. Use screws which are less than2/5q long in their place.6 screws must be used to secure each inner member. When using the 22q long sliderails, secure the screws at 4 locations.2 Attach the outer member brackets to the rack.Check that the height is the same for the left and right brackets.3 Remove the four screws at the front for attaching the left and right side panels.4 Attach the AJ-MA75P rack-mounting adapters with included 4 screws.5 Remove the 4 rubber legs from the bottom of the unit, and install the unit in the rack.After the unit has been installed, check that it moves smoothly along the rails.• Keep the temperature inside the rack to between +41°F (5°C) and +104°F (40°C).• Bolt the rack securely to the floor so that it will not topple over when the VTR is drawn out.Attach the inner members at thesame symmetrical positions on theleft (L) side.Note: The letters “A” to “H” are notactually marked on the side panels.Table 1 Locations where the screws are secured on right (R) side ofinner members of slide rails18q Chassis TrakCC3061-99-0400B, E, GPart NumberScrew holes to be used22q Chassis TrakCC3001-99-0191C, HRack-mounting adaptersFasten it to therack with setscrews.EIA standard rackA B C D E F G H