– 65 –USER menuItemSettingNo.SuperimposedNo.SuperimposedDescriptiondisplaydisplay500VITC0000BLANKBLANK0001THRU501VITC000010LPOS-1::000616L::.001020L502VITC000010LPOS-2::000818L::001020L503REGEN0000REGEN0001PRE504RUN MODE0000REC0001FREE505TCG0000TC&UBREGEN0001TC0002UB506REGEN0000AS&INMODE0001ASSEM0002INSRT0003SW508BINARY0000000GP0001001000201000030110004100000510100061100007111The underline on the setting item denotes the initial setting.For selecting whether to output the VITC signal at the posi-tions selected by setup menu items No. 501 (VITC POS-1)and No. 502 (VITC POS-2).0: VITC signals are not output.1: VITC signals are output.For setting the position where the VITC signal is to be inserted.This sets the position where the VITC signal is to be inserted.• The same line as the one used for the setup menu itemNo. 502 (VITC POS-2) setting cannot be set.• This setting takes effect only with the SD output.This sets the position where the VITC signal is to be inserted.• The same line as the one used for the setup menu itemNo. 501 (VITC POS-1) setting cannot be set.• This setting takes effect only with the SD output.Thissetsthesynchronizationoftheinternaltimecodegenerator.0: The time code reader is synchronized with the time coderead from the tape.1: What the time code generator will be synchronized with canbe preset using either the operation panel controls or theremote controller.This sets the operation mode in which the time code of theinternal time code generator is to advance.0: The time code advances only during recording.1: It advances while the power is on regardless of the modewhich has been established.This selects the signal to be regenerated when the TCG (timecode generator) is in the REGEN mode.0: Both the time code and user’s bit are regenerated.1: Only the time code is regenerated.2: Only the user’s bit is regenerated.This selects whether the time code is to be regenerated duringautomatic editing using the unit’s control panel.0: The time code is regenerated with assemble or insertediting.1: The time code is regenerated with assemble editing.2: The time code is regenerated with insert editing.3: The setup menu item No.503 (REGEN) setting is followed.This sets the usage status of the user bit of the time codegenerated by the TCG.0: NOT SPECIFIED (character set not specified)1: ISO CHARACTER (8 bits character set based on ISO646,ISO2022)2: UNASSIGNED 1 (undefined)3: UNASSIGNED 2 (undefined)4: UNASSIGNED 3 (undefined)5: PAGE/LINE6: UNASSIGNED 4 (undefined)7: UNASSIGNED 5 (undefined)Setup menus