24Setup menus (continued)The underlined items indicates the initial setting.USER menu No./Item Description No./Item Description115EJECT SWINHThis selects whether to enable ordisable the operation of the EJECTbutton on the front panel.0000 REC :Operation is disabled while the unit isin the recording mode.0001 OFF :Operation is enabled in all modes.120EJECT EE SELThis selects the modes for the pictureand sound output when the tape isejected.0000 EE : EE mode0001 BLACK :The picture turns black, and the soundis muted.0002 GRAY :The picture turns gray, and the soundis muted.Note:The IEEE1394 digital output video will beblack even if GRAY is selected.121F/R EE SELThis selects whether the EE mode orplayback mode is to be establishedduring fast forwarding or rewinding.0000 EE : EE mode0001 TAPE : Playback mode122STOP EE SELThis select whether the EE mode orplayback mode is to be establishedwhen operation is stopped.0000 EE : EE mode0001 TAPE : Playback modeNote:The selection is complied with even in thestandby OFF mode. However, the picturewill turn gray (black for IEEE1394 digitaloutput) when TAPE is selected.160MEMORYMODEThis sets the repeat play mode.0000 OFF :No repeat play (normal operation)0001 M-STOP :The tape stops near the BEGIN point when aFF or REW operation has been performed.0002 REPT1 :During playback, the tape is rewoundto the BEGIN point and stopped whenthe END point is reached.0003 CONT :During playback, the tape is rewoundto the BEGIN point and then played,and these steps are repeated whenthe END point is reached.161CTL BGNorTC BGNThis sets the BEGIN point in the repeatplay mode.Whether TC or CTL is displayed on the counterwhen the COUNTER button is pressed is sethere. When there is no setting, --:--:--:-- appears,and the tape start serves as the BEGIN point.162ENDThis sets the END point in the repeatplay mode.Whether TC or CTL is displayed on the counterwhen the COUNTER button is pressed is sethere. When there is no setting, --:--:--:-- appears,and the tape end serves as the END point.163REPT MODEThis sets the output image when thetape returns to the BEGIN point in therepeat play mode.0000 FREEZE :The tape returns to the BEGIN pointwhile the playback image at the ENDpoint remains frozen.0001 BLACK :The tape returns to the BEGIN point whilea BLACK picture remains on the screen.0002 EE_SEL :The tape returns to the BEGIN pointwith an image which is in compliancewith the setup menu item No.121 (F/REE SEL) setting.Note:If, when FREEZE has been selected, theEND point has been set at the tape end,the playback image will not be frozenproperly. Set the END point in a rangewhere pictures have been recorded.202ID SELThis sets the ID information to bereturned to the controller.0000 OTHER :0001 DVCPRO :0002 ORIG :Notes:• ID information of any VTR except for theDVCPRO’s is set in OTHER.• The ORIG setting should only be usedwhen a Panasonic controller (AG-A850etc. sold separately) is connected.114REC INHLAMPThis selects whether to cause the RECINH lamp to flash or light up when thecassette has been set to the accidentalerasure prevention status.0000 LIGHT : The lamp lights up.0001 FLASH : The lamp flashes.Note:When the REC INHIBIT switch is set toON, the REC INH lamp always lightsregardless of the general setting status.USER menu No./Item Description
