434Chapter 4 Adjustments and settings for recording#< VF MARKER >MKR:ATABLE :ACENTER MARK :1SAFETY ZONE :2SAFETY AREA :90%FRAME SIG :4:3FRAME MARK :OFFFLAME LVL :15#< CAMERA ID >ID1 : ABCDEFGHIJID2 : ABCDEFGHIJID3 : ABCDEFGHIJ4-7-6 Setting the camera IDThe camera ID is set on the CAMERA ID screen.Up to ten alphanumerics, symbols and spaces can be used.The camera ID is not displayed while the setting menu isdisplayed even if color bar signals are output.4-7-5 Setting the marker displaysON, OFF or the display type can be selected for the displaysof the center marker, safety zone markers, safety zone areaand frame marker. To make the selection, perform menuoperations to open the screen from the VFpage and select the display mode for each item.For details on operation, refer to “4-6-2 Basic menuoperations.” 1 Perform a menu operation to open the screen from the OPERATION page.2 Turn the JOG dial button to move the arrow (cursor) tothe “ID 1: to 3:” item.±±: Message is to bedisplayed.aa: Message is not tobe displayed.Setting change/adjustment result messages and display modesSituation in which message is displayed MessageDisplay modesetting1 2 3aa aa ±±When the filter selection has been changed Filter: n (n=1, 2, 3, 4), m (m=A, B, C, D)aa aa ±±When the gain setting has been changed GAIN: n dB(n= –3, 0, 3, 6, 9, 12, 15, 18, 21, 24, 27, 30)aa aa ±±When the WHITE BAL switch setting has been changed WHITE: n (n=ACH, BCH, PRESET)aa ±± ±±When the OUTPUT/AUTO KNEE switch has been setto AUTO KNEE or OFFAUTO KNEE: ON (or OFF)aa ±± ±±When the shutter speed/mode setting has been changed SS: 1/100 (or 1/120, 1/250, 1/500, 1/1000, 1/2000, S.SCAN)aa ±± ±±When the white balance (AWB) has been adjusted Example) AWB A OK 3.2Kaa ±± ±±When the black balance (ABB) has been adjusted Example) ABB OKaa aa ±±When the extender has been selected Example) EXTENDER ONaa ±± ±±When a user button has been selected Example) UM: S.GAIN 30 dBaa aa ±±When a marker select button has been selected Example) MKR: Aaa ±± ±±When in iris overwrite status Example) ++ F 5.64-7-4 Display modes and settingchanges/adjustment resultmessagesBy setting the display mode item, it is possible to selectvarious display methods for the changes made in the settingsand for the messages advising the user of the adjustmentresults: for instance, the items displayed can be limited to aselect number or not displayed at all. To select the displaymode, perform menu operations to open the screen from the VF page and select the setting for the DISPMODE item.For details on operation, refer to “4-6-2 Basic menu operations.”#< VF DISPLAY >DISP CONDITION :NORMALDISP MODE :3VF OUT :YVF DTL :3ZEBRA1 DETECT :070%ZEBRA2 DETECT :085%ZEBRA2 :SPOTLOW LIGHT LVL :35%ECU MENU DISP. :OFF50M INDICATOR :OFFMARKER/CHAR LVL :50%The MKR: A indication at the upper right of the screen showsthe display status. To check the settings for TABLE B, pressthe MARKER SELECT so that MKR:B is displayed.
