67Chapter 5 Preparation55-8 Attaching the rain coverExample showing use of the SHAN-RC700 raincover≥ Before connecting or disconnecting the dedicated cable, beabsolutely sure to set the POWER switches on the unit andthe AJ-EC3P to OFF.≥ If the ECU DATA SAVE item on the screen isset to OFF, the camera related settings among theadjustments and settings performed using the AJ-EC3P willbe erased when the unit’s POWER switch is set to OFF. Inaddition, it will not be possible to write this data to the setupcard.It is however possible for the menu content settings to bewritten on the setup card.When the unit is connected once again to the AJ-EC3P, thesettings of the AJ-EC3P are restored.≥ When ON has been selected as the ECU DATA SAVE itemsetting on the screen, the adjustments andsettings performed using the AJ-EC3P will not be erasedeven when the unit’s POWER switch is set to the OFFposition.≥ The unit’s USER switch does not function when the AJ-EC3P is connected.≥ When the AJ-EC3P is used to control the unit’s shutter, theshutter speed settings on the unit’s menu are used ratherthan the shutter speeds engraved on the AJ-EC3P. Thecorrespondence between the shutter speed indications onthe AJ-EC3P and the unit’s shutter speed settings areshown in the table below.5-9 Connecting the extensioncontrol unit (AJ-EC3P)By connecting the AJ-EC3P extension control unit (optionalaccessory), some of the functions can be operated by remotecontrol.When the AJ-EC3P is connected and the POWER switcheson the unit and AJ-EC3P are set to ON, the unit isautomatically set to the remote control mode.Tighten the cord.Close using the fastener.Close using the fastener.AJ-6 5∫ 1ECU connectorAJ-EC3PDedicated cableAJ-EC3P shutter speed indication Unit shutter speed setting100 (60) POSITION1120 POSITION2250 POSITION3500 POSITION41000 POSITION52000 POSITION65-10 Attaching the FRONTAUDIO LEVEL control knobWhen the FRONT AUDIO LEVEL control is to be operatedfrequently, the accessory knob can be attached to make iteasier to operate the control.FRONT AUDIOLEVEL control Knob (accessory)Screw IndexmarksScrew(accessory)Remove the screw at the center of the FRONT AUDIO LEVELcontrol, and secure the accessory knob to the control and unitbehind using the same screw (accessory). Make sure that theindex mark on the knob side is aligned with the index mark onthe control side.5
