Panasonic ANUP5204 User Manual

Panasonic ANUP5204 User Manual Manual pdf 25 page image

ANUP5204 AicureIrradiation258-2. Timer IrradiationStart irradiation at a predetermined time, and irradiate for the amount of time set. Before irradiation, set and/orcheck the UV intensity setting and irradiation time (1.0 to 99.9 seconds/100 to 999 seconds).See pp. 31 to 32 for details on checking or setting the UV intensity. Note, however, thatduring timer irradiation, it is not possible to change the UV intensity.Setting/Checking the Timer Time1 On the operation panel, press the "TIME" button until youhear a beep.The "TIME" LED under the display lights, and the currenttimer setting appears in the display (in seconds).If you need to change the setting, follow steps 2 to 4,below, to set the timer value.If the setting does not need to be changed, beginirradiation in this state.2 Press the "SET" button until you hear a beep. The "TIME"LED begins to flash.3 Press the up and down arrow buttons to change the value(seconds).Press the up arrow button to increment the value.Press the down arrow button to decrement the value.Press and hold one of the buttons to speed the rate ofincrease/decrease.The value can be set up to 99.9 seconds inincrements of 0.1 seconds, and from 100 secondsand beyond in increments of 1 second.4 Press the "SET" button until you hear a beep (at least 1second)If this is the value you wish to set, press the "SET" button toregister it. The "TIME" LED stops flashing, and lights solidly.WarningWarningWarning