Panasonic AW-RP50E Operating Instructions Manual

Also see for AW-RP50E: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Panasonic AW-RP50E Operating Instructions Manual Manual pdf 34 page image

33 (E)Connections Changing the IP addressesof the camera numberscontrolled by the unitUse the steps below when connecting the remotecameras (thorough a router) whose IP addressescannot be set by following the steps in “Auto IPsetting”. Setting the IP addressesOn the [SYSTEM] menu, select [CAM IP ADR], anddisplay [IP:CAM1] to [IP:CAM100]. The IP addressesof the camera numbers can now be changed.Even when “NoAsign” or “Serial” has been selectedas the [CAM1] to [CAM100] setting of [CAMERA CTL]on the [SYSTEM] menu, the IP addresses can still bechanged.1.IP:CAM1 ▼192.168.000.100The IP addresses are set for all the camera numbers[CAM1] to [CAM100].Initial values:CAM1 (192.168.000.010)CAM100 (192.168.000.109) Memo If the unit’s IP address has been changed using the[IP ADDRESS] item of [NETWORK] on the [SYSTEM]menu, the IP addresses of the camera numbers whichwere set to “NoAsign” for the [CAM1] to [CAM100]item of [CAMERA CTL] on the [SYSTEM] menu andwhich are higher than the unit’s IP address, will beautomatically re-set in the sequence of the cameranumbers set to “NoAsign” starting with the lowestnumber.When the IP addresses are changed, a check for IPaddress duplication is conducted.A check is carried out to verify whether there is anyduplication with the IP addresses of the cameranumbers which were set to “Network” for the [CAM1]to [CAM100] item of [CAMERA CTL] on the [SYSTEM]menu.If duplication is found, the “Duplicate!” is displayed forthree seconds, and the IP addresses cannot be set.1.IP:CAM1Duplicate!The IP addresses set by following these steps arethe IP address of the camera numbers controlledby the unit.The IP addresses of the remote cameras are notchanged.Note