Panasonic AW-RP50E Operating Instructions Manual

Also see for AW-RP50E: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Panasonic AW-RP50E Operating Instructions Manual Manual pdf 36 page image

35 (E)Selecting the remote cameras to be operatedUp to five remote cameras to be operated can beselected using the CAMERA STATUS/SELECTIONbuttons.When one of the CAMERA STATUS/SELECTIONbuttons 1 to 5 is pressed, the indicator of thecorresponding button lights.The statuses of the remote cameras assigned toCAMERA STATUS/SELECTION buttons 1 to 5 canbe identified by the lighting statuses of the indicatorsabove the buttons.R/B GAIN R/B PEDSYSTEMSETUPCAMERASCENE/MODEDETAILDELETESTOREPAGEMENU F2 EXITUSER2USER1PT ACTIVAUTOIRIS CAMERA STATUS / SELECTIONPRESET MEMORY / MENUGAIN/PED1 2 3AWB/ABB4SHUTTER51 2 3 4 56 7 8 9 10Indicator lighting statuses and remote camera statusesIndicatorlighting status Remote camera status The unit and remote cameraconnectionsOff No remote camera has been assigned to the corresponding button.(“NoAsign” is set for the remote camera connection.) The power of the remote camera has not been turned on. (1, 2)IP connection/Serial connectionLights (3)(orange)The remote camera is in the standby status. IP connection/Serial connectionBlinking(orange)It is not possible for the unit to be connected to the remote cameraconcerned because five other AW-RP50 remote camera controllershave already been connected.IP connectionLights(green)The unit is now connected with the remote camera. IP connection/Serial connectionBlinking(green)The remote camera concerned is connected to an AW-RP50 remotecamera controller which is other than the unit. IP connectionLights(red)The image of the remote camera concerned is now on the air.(The OA tally signal is received over the network or at the GPI inputconnector.)IP connection/Serial connectionBlinking(red)The remote camera concerned is connected to another AW-RP50remote camera controller, and the image of the its remote camera isnow on the air.IP connection1: Follow the steps set forth in the “How to turn the power of the remote cameras on and off” in the Settings> Operating Instructions, and turn on the power of the remote camera.2: When the AW-PH400 is connected through the protocol converter (AW-IF400), the indicator also will go off when theLAN cable has been connected or disconnected.Follow the steps set forth in the “How to turn the power of the remote cameras on and off” in the Settings> Operating Instructions, and turn off the power of the remote camera and then turn it back on.3: This is “Off” when the AW-PH400 is connected through the protocol converter (AW-IF400).