16The underlined values are factory preset setting values.*1 Even if FILM gamma is changed during 2 screen display, only the main window is set, and the changes are notreflected in the sub window.*2 When “RGB-COMP.” is selected in “YPBP R/RGB” in the “INPUT SELECT” menu (J page 21), this does not operate.*3 The following sharpness values can each be set,1) VIDEO system input line (VIDEO,Y/C)(Factory settings are SHARPNESS MODE : LOW,SHARPNESS H/V : 0)2) any other input line’s HD (Factory settings are SHARPNESS MODE : HIGH, SHARPNESS H/V : 0)3) any other input line’s SD (Factory settings are SHARPNESS MODE : LOW, SHARPNESS H/V : 0)and the setting values for the selected input signal from within this group is displayed. The adjustment status isdisplayed in the bottom right when selected.*4 When “VAR1”, “VAR2” or “VAR3” is selected, the monitor switches to WB adjustment mode (J page 17).*5 When selecting USER0–631) Push [ENTER] (USER changes to blue). 2) Select 0–63 with [ , ], and push [ENTER].VIDEO CONFIGSub menu Settings ExplanationGAMMASELECT*2 *1Used to select the gamma curve.When FILM is selected, mark is displayed in the topleft of the screen.FILM GAMMA*2 Used to select the type of FILM gamma mode. VARICAM use When using other types than VARICAMCOLOR TEMP. *5Used to select the color temperature. Adjustable settings 0–63 (color temperaturearound 3000K–9300K) Color temperature around 9300K Color temperature around 6500K Color temperature around 5600K WB adjustment mode *4 WB adjustment mode *4 WB adjustment mode *4SHARPNESSMODE*2 *3Used to select the width of the sharpness edge. Thin edge Thick edgeSHARPNESS H*2 <0–30> *3 Used to set the sharpness in the horizontal direction.When adjusting, the item display moves to the lower part of thescreen.SHARPNESS V*2 <0–30> *3 Used to set the sharpness in the vertical direction.When adjusting, the item display moves to the lower part of thescreen.I-P MODE*2 Used to set the mode for IP change. Within Field Normal modeMONO*2 Used to switch between color and monochrome (MONO). Color Monochrome* When this is ON, the picture adjusting knob [CHROMA] settingis fixed at 0.ANAMO*2 If an Anamo lens has been used on the camera, and input throughSDI 720/60P, 59.94P, the picture is resized to Anamo sizemagnification. (a vertically compressed signal can be amplifiedvertically and corrected when it is displayed.)SD ASPECT*2 <4:3><16:9>Used for setting the aspect ratio settings when using SD signalinput.<4:3> 4:3 display <16:9> 16:9 displaySCAN*2 Used to set under-scan and normal display.Normal display Under-scanNOISE WIPE*2 This makes a fluid and smooth contrast obtainable.This is especially effective for continuously changing the contrastof the source signal or CG signal when the S/N is very high. Noise reduction mode. Depending on the camera, this modecan be especially effective for dark scenes. We recommendleaving this setting “ON” under normal conditions.Main Menu (continued)