Panasonic BT-LH1700W Operating Instructions Manual

Also see for BTLH1700W - 17" HD MONITOR: Brochure & specs Installation instructions

7POWER switchThis switches the power supply ON/OFF. When the power is ON, the LED (green) lights up.INPUT SELECT buttonThis selects the signal input line. The green LED light above the button indicates the selected input signal.VIDEO : Video inputY/C : Y/C inputSDI1 : Serial digital interface input (HD/SD compatible)SDI2 : Serial digital interface input (HD/SD compatible)YP BP R/RGB : Analog component (YPB P R) or RGB input. Also compatible with PC input RGB.* When using PC Input, select “RGB-COMP.” from “YP BP R/RGB” in the “INPUT SELECT”menu (Jpage 21).* The monitor retains the input signal settings selected from the last time the monitor was swiched ON or OFF.MENU buttonThis is used for menu display, selecting settings, and adjustments.MENU : Push to display or exit the menu, and to return to the previous menu screen., : Push to move the cursor up or down, or to select an item.ENTER : Push to confirm a setting, and to display a submenu.FUNCTION buttonFUNCTION 1 : Carries out the item selected in the menu.FUNCTION 2 : Carries out the item selected in the menu.Picture adjusting knobPHASE 0 – 60 (30)CHROMA 0 – 60 (30)BRIGHT 0 – 60 (30)CONTRAST 0 – 60 (50)( ) denotes factory preset valuesA rotating knob that can be pushed to operate. You can display and adjust the menu settings by pushing theknob. The setting values are saved by pushing the knob again.When values are changed from the factory preset values, the LED above the knob (amber) lights.The setting values are loaded when the monitor’s power is switched ON. The setting values are saved whenthe knob is pushed, or when 10 seconds pass after changing the settings. However, operating changescannot be made in the following cases.* When the control lock is on, the key mark appears and setting values cannot be changed (J page 22).* When the MONO function is ON (J page 16), [PHASE] and [CHROMA] operations are disabled.* When using “RGB-COMP.” input, [PHASE] and [CHROMA] operations are disabled.* While operating HV DELAY (J page 17) (when set to any other setting than OFF), [BRIGHT] operation isdisabled.Volume knobYou can adjust the speaker volume by rotating the volume knob.SpeakerAudio input from the AUDIO input terminal or SDI terminal (embedded audio) can be heard.* The BT-YAE1700G embedded audio unit (optional) must be attached to hear audio through embeddedaudio.Front panelControls and Their Functions (continued)