|
17g WB adjustment modeYou can adjust “WHITE BALANCE VAR1” – “WHITE BALANCE VAR3” (WB) by selecting “VAR1” – “VAR3” in“COLOR TEMP.” in the “VIDEO CONFIG” menu.The underlined values are factory preset setting values.*1 When adjusting, the item display moves to the lower part of the screen.The underlined values are factory preset setting values.*2 This function is disabled while in 2 screen display mode.*3 These functions are disabled when the control settings are in GPI mode.*4 If these settings are changed, the menu settings will also change.*5 When “RGB-COMP.” is not selected in “YPBP R /RGB” in the “INPUT SELECT” menu, “NOT RGB-COMP.CH-” isdisplayed, and this does not operate.*6 This function will not work when “RGB-COMP.” is selected in “YP B P R/RGB” in the “INPUT SELECT” menu.Sub menu Settings ExplanationCOLOR TEMP. Used to select the color temperature that will become thebasis for adjustments.– 63> Adjustable settings 0–63 (colortemperature around 3000K–9300K) Color temperature around 9300K Color temperature around 6500K Color temperature around 5600KWB-HIGH RED <0–60>(Factory preset settings: 30)Used to adjust the WB in the HIGH level R component. *1WB-HIGH GREEN Used to adjust the WB in the HIGH level G component. *1WB-HIGH BLUE Used to adjust the WB in the HIGH level B component. *1WB-LOW RED Used to adjust the WB in the LOW level R component. *1WB-LOW GREEN Used to adjust the WB in the LOW level G component. *1WB-LOW BLUE Used to adjust the WB in the LOW level B component. *1RESET This returns the “WB-HIGH RED” – ”WB-LOW BLUE”settings to the factory presets.SYSTEM CONFIGSub menu Settings ExplanationBACKLIGHT < 0–60 > Used to adjust the brightness of the liquid crystal backlight.FUNCTION1 SELECT>WINDOW>Used to select the functions assigned to [FUNCTION1] and[FUNCTION2] (front buttons). *2Displays the synchronizing signal (horizontal, vertical).The display is switched in the following order.OFF J H-Delay J V-Delay J HV-Delay J OFF *5Used to automatically adjust the PC display.Used to cut the red and green signals. You can check the hue (PHASE)and depth of color (CHROMA). This is switched between ON/OFF bypushing the button.You can switch between “NORMAL” and “FILM”.*3*4Used to switch between “16:9” and “4:3”.*3*4You can switch between “UNDER” and “NORMAL”. *3*4You can perform the settings for 2 screen display mode. *3*4*6No settingsFUNCTION2 SELECT>WINDOW>Main Menu (continued) PreviousNext |