|
21The underlined values are factory preset setting values.*1 “AUTO” is set when the monitor is shipped from the factory, but if there are concerns about noise etc. from outside theinput signal, we recommend assigning specific format.g COMP.The following menus are switched by selecting “RGB-COMP.” in “YPB P R/RGB” in the “INPUT SELECT” menu.The underlined values are factory preset setting values.*1 “EXECUTING” is displayed while “AUTOSETUP” is being executed, and “COMPLETE” is displayed when“AUTOSETUP” is completed.If “AUTOSETUP” cannot be completed, “INCOMPLETE” is displayed.*2 Each RGB-COMP. input compatible format can be adjusted.INPUT SELECTSub menu Settings ExplanationVIDEO / Y/C Used to select the input format for VIDEO and Y/C input. *1 Either NTSC or PAL is automatically selected. NTSC PALNTSC SETUP <75><00>Selects the NTSC setup level.<75> Select this when using with a setup signal of7.5 IRE. (The inner parts of the monitor are setto the 7.5 IRE setup level to suit the black level)<00> Select this when there is no setup level signal.YP BP R /RGB BP R>Selects either YP BP R (Component) or RGB input mode.BPR> Selects the YPBPR signal. Selects the video RGB signal..> Selects the PC RGB signal.COMPONENTLEVELSelects YP B P R (Component) signal input level. When the signal level specified in SMPTE isChroma 100 IRE P B, P R = 0.7 Vp-p. Select this when connecting a betacam orsimliar devices set to 7.5 IRE. (The inner partsof the monitor are set at 7.5 IRE setup level tosuit the black level) Select this when connecting a betacam or similardevices that are not setup to the IRE level.RGB SYNC Selects the SYNC when using RGB-VIDEO input. Select when a synchronizing signal issuperimposed on the G signal. Select when an external synchronizing signal isreceived in synchronization.COMP. Performs analog PC settings. (Refer to “COMP.” below)Sub menu Settings ExplanationAUTOSETUP *1 Screen automatic adjustment is performed when “RGB-COMP.” is selected in “YP B P R/RGB” in the “INPUT SELECT”menu. “AUTOSETUP” is performed if a different screen isdisplayed, and “YES” is selected.H POSITION <0–60>(Factory preset settings: 30)Used to adjust the picture display position in the horizontaldirection. *2V POSITION <0–60>(Factory preset settings: 30)Used to adjust the picture display position in the verticaldirection. *2PHASE <0–31>(Factory preset settings:J page 22)Used to adjust the clock phase with 1/32 clock phases. *2CLOCK <700–1800>(Factory preset settings:J page 22)Used to adjust the sampling clock in dot units. *2WXGA/XGA Switches between WXGA and XGA.Main Menu (continued) PreviousNext |