Panasonic BT-LH900 Operating Instructions Manual

Also see for BT-LH900: Brochure & specs

Panasonic BT-LH900 Operating Instructions Manual Manual pdf 11 page image

11How to use the on-screen menusFour kinds of information—menus, status displays, image control settings and battery voltage—can be displayed on thescreen.Menu displayThis display appears when the MENU/EXIT button ispressed. If no further action is taken for the next 120seconds, the display will be automatically cleared.The position where the display appears on the screen canbe changed using the marker setting.For details on the menu, refer to “MAIN MENU” (page 15).[MAIN MENU]MARKER 4VIDEO CONFIG 4SYSTEM CONFIG 4OSD CONFIG 4GPI 4INPUT SELECT 4CONTROL 4EXIT SEL ENTER1MENU XW ENTERStatus displayThe status display information is displayed under thefollowing conditions while the menu display is not on thescreen.≥ When the input signals have been switched≥ When the input channel has been changed≥ When no signals are suppliedThe display location and display time can be changed usingthe menu settings. When images are adjusted using theimage controls while the status display information is on thescreen, the display is cleared, and the settings adjusted bythe controls are displayed instead.SDI1 1080/60ICRCCDC150V 60%.1231 Channel and signal formatThe channel which has been selected—whether SDI 1,SDI 2, VIDEO, YPBPR or RGB—is displayed here.Indicated as the signal format is the format of the signalswhich have been input. However, "UNSUPPORTEDSIGNAL" will appear if signals which are not supportedhave been input.Similarly, “UNSUPPORTED SIGNAL” will also appear ifsignals not selected as the FORMAT item setting on theINPUT SELECT screen of the main menu are input evenwhen those signals are supported.For details on the signals supported and format displays,refer to page 12.2 Warning displayThis appears when an error has occurred or when aspecial mode is being used.CRCC This indicates a CRCC error, and it appearswhen the SDI signals contain an error.FILM This appears when the film mode (FILM) hasbeen selected as the GAMMA SELECT itemsetting on the VIDEO CONFIG screen of themain menu.This appears when REMOTE has beenselected as the CONTROL item setting on theCONTROL screen of the main unit. Themonitor controls will no longer function at thistime.3 Battery voltage displayThis indicates the voltage level of the battery. If an AntonBauer digital battery is being used, its remaining level isindicated as a number of "[//]" blocks and as apercentage along with the voltage value.