Panasonic BT-LH900 Operating Instructions Manual

Also see for BT-LH900: Brochure & specs

Panasonic BT-LH900 Operating Instructions Manual Manual pdf 6 page image

64 Image controlsThese controls are used to adjust the peaking/colorphase, chroma, brightness and contrast. When a controlis pushed in, it pops out to enable adjustment. When anumerical value is changed from the default setting, thelamp to the left of the control lights.The adjustments performed using these controls arevalid only when the controls are in the "out" position, andwhen a control is pushed back in, the value adjusted bythat control is returned to its default setting.1 PEAK/PHASE (PEAKING/PHASE)This control is used to adjust the peaking or phase.Which of these is to be adjusted is set using thePEAKING/PHASE item on the SYSTEM CONFIGscreen.≥ PEAKINGThis function is selected when the monitor is to beused as a viewfinder.It is used to set the edge sharpness. Any valuefrom 0 to 30 can be set: the higher the value, thesharper the edges. The default setting is 0.≥ PHASEThis function is selected when the monitor is to beused as a monitor.It is used to set the color phase of the screen. Anyvalue from 0 to 60 can be set. The default settingis 30.≥ When the blue-only function is ON, the controlfunctions as the PHASE control regardless of thesetting.≥ The color phase cannot be adjusted when RGBsignals are input.2 CHROMAThis control is used to adjust the image chroma. Anyvalue from 0 to 60 can be set. The default setting is30.The chroma cannot be adjusted when RGB signalsare input or when the MONO setting is ON.3 BRIGHTThis control is used to adjust the image brightness.Any value from 0 to 60 can be set. The default settingis 30.However, the brightness cannot be adjusted whenblanking is displayed using the HV DELAY function.4 CONTRASTThis control is used to adjust the image contrast. Anyvalue from 0 to 60 can be set. The default setting is50.5 FUNCTION/ENTER buttonThis button is used to enter changes or settings whilea menu is displayed.If there is no menu display, the button's functionchanges depending on which FUNCTION item on themenu is selected. One of the following three itemscan be selected. (Refer to page 19)UNDEF: No function is allocated to this item.HV DELAY : Image blanking is displayed. Each timethe button is pressed, the blankingdisplay is switched by one setting in thefollowing sequence: H blanking display> V blanking display > H and Vblanking display > no blanking display.WFM ON/OFF : The Y signal (luminance) waveform isdisplayed at the bottom right of theimage. When the button is pressedagain, the display is cleared.When waveforms are displayed in the16:9 mode, the image displayed on thescreen moves to the upper part of thescreen so that it will not besuperimposed onto the waveformdisplay.Parts and their functionsPEAK/PHASE CHROMA BRIGHT CONTRAST1 2 3 4≥ In order for this function to be used, it is necessary toselect WFM as the FUNCTION item setting on theSYSTEM CONFIG screen, and then select FUNCTIONas the WFM item setting.≥ The WFM function is a simplified one and, as such,finely detailed waveforms may not be displayedaccurately.In addition, differences in the input signal format orinput function may result in the display having adifferent horizontal width.The image remains unchanged in the 4:3mode.>WFM function OFF WFM function ONWFM>WFM function OFF WFM function ONWFM