Panasonic CF-52 Series Reference Manual

Also see for CF-52 Series: Supplementary guide Supplementary guide Supplementary instructions Getting started guide Supplementary instructions

111Troubleshooting (Advanced)User cannot use enrolled finger. (e.g.injury)z It is strongly recommended to enroll at least two fingers to avoid this problem.If you enrolled multiple fingers, simply use other finger. If you only enrolled onefinger that can be used, we recommend to use the [Manage Fingerprints] wiz-ard and enroll additional fingerprints.If none of your enrolled fingers can be used, follow this procedure:A Log on to Windows as an Administrator.You can always access the computer by using your Windows log onpassword. In convenient mode, any user can access the computer byusing your Windows log on password.B Update the enrolled fingerprints.To be able to fully use Protector Suite, you need to have usable enrolledfingerprints. Enter the [Manage Fingerprints] wizard.• If you do not use backup password, you can still enter using the Windowspassword.• If you use backup password, you can enter using the backup password.• If you do not use backup password, there is no other way to add a differentfingerprint. In this case we recommend either to wait until your finger isusable again (e.g. the injury heals), or to delete the passport (Use [Deleteuser data] wizard) and then reenroll new fingerprints.Please note that in the latter case all your stored secret data (passwords, [FileSafe] encryption keys [Personal Safe] data) will be lost. To perform the deleteoperation it is necessary to cancel the fingerprint verification operation to getto the password dialog, then enter your Windows log on password.• To access [File Safe], [Personal Safe]If you did not perform the procedure in step B or it did not work, you can stillaccess [File Safe] by using the [File Safe] backup password, [Personal Safe]by using the [Personal Safe] backup password.TPM failure. z If you use fingerprint authentication with TPM (Trusted Platform Module) andTPM is broken, erased or disabled, the [Multifactor] will not work anymore.If you do not use the [Multifactor] backup password, refer to “Starting Over”(Î page 61). Otherwise, if you use backup password, you can follow thesesteps:A Click (Start) *6 - [All Programs] - [Protector Suite] - [Control Center].B Click [Identity] - [Multifactor].C Set the method of authentication except for “fingerprint + TPM ∗∗”. Fingerprint Reader (only for model with Fingerprint Reader)