![Panasonic CPC-EX Installation Manual Manual pdf 172 page image](https://manuals-archive2.s3.amazonaws.com/5428140/1dd9905c886eb037092e81fd753fb5a9172f.jpg)
Appendix A. EX 1.0 Feature Update Section 300-InstallationPage A-12 DBS Manual - Revised April 2000 DBS-2.3/9.2-300Analog AdapterDescription The Analog Adapter (VB-44100) consists of a base adapter and PC boardwhich is installed on the underside of the phone. It is used to connect the44-Series large-display phone to an analog device such as an SLTtelephone, cordless phone, FAX machine, or modem. This allows the samephone line to be used to alternate between normal phone calls and analogcommunications. (To install, see the instructions supplied with VB-44100).Operation The first device to go off-hook will seize the line (off-hook is either liftingthe handset or pressing the ON/OFF key). If the analog device goes off-hook first, the large-display phone will be unable to dial or go off-hook.You can choose which device will ring by going off-hook at either thedigital key telephone or the analog device and dialing *71. The digital keytelephone display will reflect “Analog port RING” or “Key Tel RING”,depending on which device is selected - the default is “Key Tel RING”.You can still answer an incoming call from either device, regardless ofwhich device is ringing. For example, if the analog device is ringing, youcan pick up the call on the digital key telephone by going off-hook beforethe analog device does. Similarly, if the digital key telephone is ringing orhas not answered a voice call, the analog device can pick up the call bygoing off-hook first.You can program the *71 ring select command into an FF key. Pressing thekey toggles between “Analog Port RING” and “Key Tel RING”. When theanalog port is set to ring, the FF key LED lights red. When the keytelephone is set to ring, the LED is off.Notes Phone Restrictions• The Analog Adapter will work on the large-display phone only (VB-44225).• A dial-pulse SLT will not function on the analog port.• Stutter Dial Tone (indicating Call-Forwarding mode, Do-Not-Disturbmode, etc.) will not function on an SLT connected to the AnalogAdapter.• An analog phone connected to the Analog Adapter cannot program oraccess speed dials.Incoming Calls• You cannot program both devices to ring simultaneously.• The “*71” code will not work if the other device is in use.