Panasonic CS-NZ9SKE Service Manual

Also see for CS-NZ12SKE: Operating instructions

Contents

Panasonic CS-NZ9SKE Service Manual Manual pdf 78 page image

7816. Servicing Mode16.1 Auto OFF/ON Button16.1.1 Mode setting by Emergency SWEmergencyOperationEmergency SW ispressed Emergency SW ispressed Emergency SW ispressed Emergency SW ispressedOperationtime check5S5S5S5SPit Pit Pit Pit Pit PitStopStopStopForcedCoolingOperationForcedHeatingOperationNormalCoolingOperationEmergencyOperationForcedCoolingOperationForcedHeatingOperationNormalCoolingOperation Emergency Operation (Auto Operation) will begin immediately when the Emergency SW is pressed and releasedwithin 5 seconds. The unit will enter into Forced Cooling Operation if the Emergency SW is pressed, and held for at least5 seconds before releasing (Code receiving sound - pit). The unit will enter into Normal Cooling Operation if the Emergency SW is pressed, and held for at least5 seconds before releasing within 5 minutes after Force Cooling Operation begins (Code receiving sound - pit pit). The unit will enter into Forced Heating Operation if the Emergency SW is pressed, and held for at least5 seconds before releasing within 5 minutes after Normal Cooling Operation begins (Code receiving sound - pitpit pit). The unit will enter into Operation Time Check Mode if the Emergency SW is pressed, and held for at least5 seconds before releasing within 5 minutes after Force Heating Operation begins (Code receiving sound - peet). The unit will enter into Forced Cooling Operation again if the Emergency SW is pressed, and held for at least5 seconds before releasing within 5 minutes after Operation Time Check Mode begins. All modes will be cancelled when it receives any remocon code.1 AUTO OPERATION MODEThe Auto operation will be activated immediately once the Auto OFF/ON button is pressed. This operationcan be used to operate air conditioner with limited function if remote control is misplaced or malfunction.2 TEST RUN OPERATION (FOR PUMP DOWN/SERVICING PURPOSE)The Test Run operation will be activated if the Auto OFF/ON button is pressed continuously for more than5 seconds. A “beep” sound will heard at the fifth seconds, in order to identify the starting of Test Runoperation (Forced cooling operation). Within 5 minutes after Forced cooling operation start, the Auto OFF/ONbutton is pressed for more than 5 seconds. A 2 “beep” sounds will heard at the fifth seconds, in order toidentify the starting of Forced heating operation.The Auto OFF/ON button may be used together with remote control to set / change the advance setting of airconditioner operation.