Panasonic CY-VHD9401N Operating Instructions Manual

Also see for CY-VHD9401N: Installation instructions Installation instructions

Panasonic CY-VHD9401N Operating Instructions Manual Manual pdf 11 page image

104 CY-VHD9401N CY-VHD9401N 105Remote Control Unit PreparationBattery Installation1 Remove the battery holder.With the remote control unit placed on a flatsurface:1 Stick your thumbnail into the groove, andpush the holder in the direction of the arrow,and at the same time2 Pull it out in the direction of the arrow using atough pointed object.Battery Notes≥ Battery type: Panasonic lithium battery(CR2025/1F) (supplied)≥ Battery life: Approximately 6 months undernormal use (at room temperature)Back sideLithium battery(supplied)Battery holderCaution:≥ Improper use of the battery may causeoverheating, an explosion or ignition, resultingin injury or a fi re. Battery leakage may damagethe product.≥ Do not expose the remote control unit to directsunlight.≥ Do not recharge, disassemble, deform or heatthe battery.≥ Do not put the battery in fire or water.≥ Immediately replace used up battery.≥ Obey local ordinances when disposing of thebattery.Monitor Position AdjustmentOpen the Display Unit1 Push the display release button [PUSH OPEN]until the display is unlocked.(Press the button with one hand while holdingthe display with the other.)2 Open the display unit by both hands until acomfortable viewing angle is reached.Close the Display UnitMove the display unit by both hands until thedisplay release button is locked.Note:≥ Always use both hands to open or close thedisplay unit.≥ Always check that the display release button islocked after closing the display unit.≥ If the display unit cannot be locked, be sure toconsult your dealer and remedy the situation.Display Unit Lateral AngleAdjustmentYou can swivel it to the left and right, 30˚ each way.Hold the display unit by the non-slip part in theupper half of it and adjust its lateral angle.[PUSH OPEN]2 Install the battery on the battery holder.Set a new battery properly with its (+) side facingup as shown in the figure.Tough pointedobjectMaximum120x30x30x123 Insert the battery holder back into its originalposition.ENGLISH7ENGLISH8