Panasonic DIGA DMR-EZ27 Operating Instructions Manual

Also see for Diga DMR-EZ27: Operating instructions Firmware instructions

Contents

68RQT8851General Issues Operation PageCannot operate the TV or SetTop Box with the unit’s remotecontrol.Change the manufacturer code on the remote control.• 58Select TV or Set Top Box mode on the remote control.• 58The remote control doesn’twork.The remote control code is wrong. Change to the correct code.• 66The batteries are depleted. Replace them with new ones.• 5Point the remote control at the remote control sensor on the main unit.• 5Remove obstacles between the remote control and main unit.• −Remove dust from the transmission window and the unit’s sensor.• −Colored glass may obstruct the signal reception/transmission.• −Don’t place the signal sensor in direct sunlight or in areas that may besubject to sun exposure.• −It may be necessary to set the code on the remote control again afterchanging the batteries.• 66It may be necessary to set the manufacturer code again afterchanging the batteries.• 58The unit is on but cannot beoperated.Some operations are prohibited by the disc.• −The unit is warm (“U59” appears on the unit’s display). Wait until “U59”disappears.• −One of the unit’s safety devices may have been activated.Reset the unit as follows:Press [POWER 8] on the main unit to switch to off.If the unit doesn’t switch to off, reset the unit (➔ 66, “To restore theunit if it freezes”).• −“U88” is displayed and the disccannot be ejected.The unit is carrying out the recovery process. Do the following to ejectthe disc:(1)Press [POWER 8] on the main unit to switch to off.If the unit doesn’t switch to off, reset the unit (➔ 66, “To restore theunit if it freezes”).(2)While the unit is off, press and hold [g] and [CH 1] on the main unitat the same time for about 5 seconds. (Ejection may take extra timedepending on discs.) The disc may be defective. Try another disc.• −Cannot eject a disc. The unit is recording.• −The unit may have a problem. Eject the disc as in (2) above.• −Startup is slow. Startup takes time in the following situations:A disc other than a DVD-RAM is inserted.The clock is not set.Immediately after a power failure or the AC power supply cord isconnected.When the unit is connected with an HDMI cable.•––––−A password screen appearsand you are unable to view orrecord.If the unit starts receiving a broadcast with the set rating information,a password screen appears and you will be unable to view or record.Enter your password to continue.• 42Time is incorrect after usingAuto Clock Setting.Try again. If the time is still incorrect, set the clock manually (➔ 38).• 57Troubleshooting GuideDownloaded From Disc-Player.com Panasonic Manuals