Panasonic DMR-BW500 Operating Instructions Manual

Also see for DMR-BW500: Operating instructions

Contents

Panasonic DMR-BW500 Operating Instructions Manual Manual pdf 94 page image

94RQT9132Changing the unit’s settings∫ Setting the proxy serverIn most cases, default settings can normally be used without makingany changes.Please use this setting when instructed to by your Internet provider.≥Set the proxy server only after the connection test is completedproperly.1 Press [FUNCTION MENU].2 Press [3, 4] to select “To Others” and press[OK].3 Press [3, 4] to select “Setup” and press [OK].4 Press [3, 4] to select “Network Settings” andpress [OK].5 Press [3, 4] to select “Proxy Server Settings”and press [OK].6 Press [3, 4] to select “Proxy Address” andpress [OK].(> 75, Entering text)After the input of “Proxy Address” is completed7 Press [3, 4] to select “Proxy Port Number” andpress [OK].8 Enter numbers with the numbered buttons andpress [OK].9 Press [2, 1] to select “Yes” and press [OK].To set back to default settingAfter performing steps 1–5 (> left)1 Press [3, 4] to select “Initialize” and press [OK].2 Press [2, 1] to select “Yes” and press [OK].Software of this unit can be updated automatically by followingmethod.≥From broadcasts≥From Internet [network connection and setting is required. (> 99)]Update of the software is done when it is in standby mode.Once the new software is found, it will start the download of thesoftware, and then the upload.Download of the software will start automatically when the power ofthis unit is turned off or when it is 3 a.m.≥The time it takes to update depends on the connection.– For Broadcast: About 2 to 5 hours– For Internet: About 1 hour(It may take longer than specified above to download becausethe download time differs depending on the networkenvironment. It is recommended to be used in a broadbandenvironment.)If you do not want to perform the software update during the standbymode, set the “Software Update in Standby” in the Setup menu to“Off”. (> 92)∫ If a software update is available, a notification isdisplayed.≥Update of the software will start when the power is turned off.∫ The unit’s display during the update≥“SW-DL” : Software is downloading.Download will stop when the power is turned on, orthe timer recording starts.≥“START”§ : Update of the software will start once the downloadis completed.≥“UPD /”§ : Software is updating.≥“FINISH” : Updated of the software has completed.§You cannot operate the unit until the update is complete.Removing the AC mains lead while the update is in progressmay damage the unit.[Note]≥If the timer recording is scheduled within the following time at thestart of the download, the download will not be executed.– For broadcast: Within 5 hours– For Internet: Within 1 hour≥You can also download the latest software from the followingwebsite and burn it to a CD-R to update the software.http://panasonic.net/support/RETURNProxy Server SettingsInitializeProxy AddressProxy Port NumberOK01Proxy Port NumberPlease input HTTP Proxy Server Port Numberand press “OK”. The number will be set to “0”by pressing “OK” when there is no numberinput.0 - Number9Software Update