Panasonic DMR E50 Operating Instructions Manual

Also see for Diga DMR-E50: Operating instructions Operating instructions Operating instructions

Contents

63Changing the unit’s settings (continued)Remote SettingPreparation≥Switch [DVD, TV] (15) to “DVD”.≥Press [FUNCTIONS] (11) to show the FUNCTIONS window.1 Use [3, 4, 2, 1] (10) to select “SETUP” and press[ENTER] (10).≥The SETUP screen appears.2 Use [3, 4] (10) to select the “Settings” tab andpress [2] or [1] (10).3 Use [3, 4] (10) to select “Remote” and press[ENTER] (10).4 Use [3, 4] (10) to select “DVD 1”, “DVD 2” or“DVD 3” and press [ENTER] (10).≥DVD 1:Select this setting on both the unit and the remote control fornormal use with one unit.≥DVD 2/DVD 3:Select this setting on both the unit and the remote controlwhen using this unit and another Panasonic unit in the sameplace. This ensures that you can operate both unitsindependently with their respective remote control.It also allows you to operate both units with a single remotecontrol, simply by changing the remote control mode on theremote control.5 To change the remote control mode on the remotecontrol itself, press [ENTER] (10) and the numericbuttons (4) corresponding to the code you want toset, [1], [2], or [3], at the same time.6 Press [RETURN] (23).Operating other Panasonic DVDequipment with the remote controlBy changing the remote control code, you can operate other DVDRecorders and players manufactured by Panasonic.Most of the DVD Recorders and players manufactured byPanasonic use the same system for their remote controls, so if youoperate them in the same place, the controls can be confused bythe different pieces of equipment. Use the following procedure tochange the remote control code to solve this problem.≥Use “1”, the factory set code, under normal circumstances.Preparation≥Switch [DVD, TV] (15) to “DVD”.Press [ENTER] (10) and the numeric buttons (4)corresponding to the code you want to set, [1], [2], or[3], at the same time.Note≥Be sure to set the same remote control code on the main unit asyou did for the remote control itself (page 59, “Settings” —“Remote”).≥The following display appears on the unit’s display if its code andthe remote control’s code are different. Change the remotecontrol’s code to suit the unit.The unit’s remote control code≥The display disappears after about 5 seconds.NSNSDisc ProtectionDIRECT NAVIGATOR CREATE PLAY LISTPLAY LISTTIMER RECORDINGTOP PLAY FLEXIBLE RECOffCartridge Protection OffFUNCTIONSSELECTENTERRETURNDISC INFORMATIONPLAYSETUPDVD-RAMTab SELECTRemoteTuningSETUPRETURNSettingsDiscPictureSoundDisplayConnectionClockOwner IDShipping ConditionDVD 1