Panasonic DMR-EH56 Operating Instructions Manual

Also see for Diga DMR-EH55: Owner's manual Operating instructions Setup guide Operating instructions

Contents

45RQT8415After performing steps 1–5 (➡ 44)§ Multiple editing is possible.After performing steps 1–7 (➡ 44)§ Multiple editing is possible.Title operationsDelete§[HDD] [RAM] [-R] [-R]DL] [-RW‹V›][+R] [+R]DL] [+RW]Press [2, 1] to select “Delete” and press [ENTER].≥Once deleted, the recorded contents are lost and cannot be restored. Make certain before proceeding.≥The available recording space on DVD-R, DVD-R DL, +R or +R DL does not increase when you delete titles.≥Available recording space on DVD-RW (DVD-Video format) and +RW increases only when the last recordedtitle is deleted. It does not increase if other titles are deleted.Properties[HDD] [RAM] [-R] [-R]DL] [-RW‹V›][+R] [+R]DL] [+RW] [-RW‹VR›]Information (e.g., time and date) is shown.≥Press [ENTER] to exit the screen.Enter Name[HDD] [RAM] [-R] [-R]DL] [-RW‹V›][+R] [+R]DL] [+RW]You can give names to recorded titles.➡ 63, Entering textSet up Protection§Cancel Protection§[HDD] [RAM] [+R] [+R]DL] [+RW]If set, this will protect the title from accidental deletion.Press [2, 1] to select “Yes” and press [ENTER].The lock symbol appears when the title is protected.Partial Delete[HDD] [RAM](➡ below, For your reference)You can remove unnecessary part of the recording.1 Press [ENTER] at the start point and end point of thesection you want to delete.2 Press [3, 4] to select “Exit” and press [ENTER].≥Select “Next” and press [ENTER] to delete other sections.3 Press [2, 1] to select “Delete” and press [ENTER].Change Thumbnail[HDD] [RAM] [-R] [-R]DL] [-RW‹V›][+R] [+R]DL] [+RW](➡ below, For your reference)You can change an image to be shown as the thumbnail picture in the TitleView.1 Press [1] (PLAY) to start play.2 Press [ENTER] when the image you want to use as athumbnail is shown.To change the thumbnailRestart play and press [3, 4] to select “Change”, then press [ENTER]at the point you want to change.3 Press [3, 4] to select “Exit” and press [ENTER].Divide Title[HDD] [RAM](➡ below, For your reference)You can divide a title into two.1 Press [ENTER] at the point you want to divide the title.2 Press [3, 4] to select “Exit” and press [ENTER].3 Press [2, 1] to select “Divide” and press [ENTER].To confirm the division pointPress [3, 4] to select “Preview” and press [ENTER]. (The unit plays 10seconds before and after the division point.)To change the division pointRestart play and press [3, 4] to select “Divide”, then press [ENTER] at the point where you want to dividethe title.[Note]≥The divided titles retain the title name and CPRM property (➡ 81) of the original title.≥Video and audio just before and after the dividing point may momentarily cut out.PropertiesNo.NameDate 026ARD11.10.2006 TimeRec time 12:190:30 (SP)MONDinosaurDIRECT NAVIGATOR Title VARD 10.10. FRI ARD 11.10.007 008HDDDIRECT NAVIGATOR Partial DeleteStartNextExit0:43.21PLAY008End- -:- -.- - - -:- -.- -Start EndHDDENTERRETURNPICTUREVIDEODIRECT NAVIGATOR Change ThumbnailChangeExit0:00.00- -:- -.- -ChangeHDD;008ENTERStart play and select the imageof a thumbnail.PICTUREVIDEODIRECT NAVIGATOR Divide TitlePreviewExit0:43.21PLAY008Divide- -:- -.- -DivideHDD PICTUREVIDEOChapter operationsDelete Chapter§[HDD] [RAM]Press [2, 1] to select “Delete” and press [ENTER].≥Once deleted, the recorded contents are lost and cannot be restored. Make certain before proceeding.≥Select “Combine Chapters” (➡ below) when you only want to delete the division point between chapters.(The recorded contents will not be deleted.)Create Chapter[HDD] [RAM](➡ below, For your reference)Select the point where you want to start a new chapter while viewing thetitle.1 Press [ENTER] at the point you want to divide.≥Repeat this step to divide at other points.2 Press [3, 4] to select “Exit” and press [ENTER].Combine Chapters[HDD] [RAM]Press [2, 1] to select “Combine” and press [ENTER].≥The selected chapter and following chapter are combined.DIRECT NAVIGATOR Create ChapterCreateExit0:43.21PLAY008HDD PICTUREVIDEOFor your reference≥Use search (➡ 35), Time Slip (➡ 36) to find the desired point.≥To find the desired point correctly, use Slow-motion (➡ 36) and Frame-by-frame (➡ 36).≥To skip to the start or end of a title, press [:] (start) or [9] (end).Editing titles/chapters