167SEP 2004Ver. 1.2DP-1520P/1820P/1820E503 XMT/RCV(V.34)B, C, D CS of modem is not able to turnON during training.FXB PCB defective.Line disconnected.504 RCV/V.34(Polling)B Polling is rejected from the remotestation.No polling original set.505 XMT/V.34(Polling)B Polling XMT is rejected. No polling original set.540 XMT ECM B No response after transmitting 3rdCTC or DCN received.Incompatible interface.541 XMT ECM D No response after transmitting 3rdEOR or received DCN.Faulty line.MJR PCB abnormal.542 XMT ECM D No response to the 3rd RRtransmitted or received DCN.Remote unit abnormal.543 XMT ECM D T5 timer (60 sec.) elapsed withoutMCF.Remote unit abnormal.544 XMT ECM D Stopped Transmission after EORTransmission.Faulty line.MJR PCB abnormal.550 RCV ECM C Timer between frames in phase Chas elapsed.Defective remote station.554 RCV ECM D Transmitted ERR after receivingEOR.Faulty line.555 RCV ECM D Transmitted PIN after receivingEOR.Faulty line and Operator Call requestedby RX side.570 RCV B Password or machine code did notmatch during remote diagnosticcommunication.571 XMT B Remote unit did not have theremote diagnostic function.580 XMT B Sub-address transmission to a unitthat has their DIS bit 49 (NSF bit155) OFF.Sub-address transmission to a unit thathas no Sub-address function.581 XMT B Sub-address Passwordtransmission to a unit that has theirDIS bit 50 (NSF bit 156) OFF.Sub-address transmission to a unit thathas no Sub-address function.582 XMT B Sub-address SEP (for Polling)transmission to a unit that has theirDIS bit 47 (NSF bit 130) OFF.Sub-address transmission to a unit thathas no Sub-address function.601 XMT ADF Door was opened during ADFtransmission.623 XMT A No original was in the ADF. (Built-in dialer engaged)Operator removed the original from theADF after dialing was completed.Original was not set properly in the ADF.630 XMT or RCV(Polling)B Redial count over. No dial tone detected. Sensor did notdetect dial tone. (Country dependent)Busy tone is detected. (Countrydependent) T1 timer (35±5 sec) elapsedwithout a signal from the receiver.631 XMT A "STOP" key was pressed duringAuto Dialing.Fax Information CodesCode Mode Phase Description of Problem Possible Cause(s)
