1 Unwind speaker wire,then fit the wire backinto the groove of thespeaker base.2 Twist and pull off the vinyl tip.3 Connect the speakers.12 RQT6912 Getting StartedPreparing the multi cradle and power supplyHousehold AC outlet(AC 120 V, 60 Hz)Fit so unitclicks firmlyinto place.The unit is in the standby condition (the [Í]indicator lights) when the AC power supplycord is connected. The primary circuit isalways “live” as long as the AC adaptor isconnected to an electrical outlet.BEFORE USEMake sure the built-in battery is attachedwhenever you use the unit.DC IN 9VPULLËRemove theinsulation sheetWhen using only the playerConnect the AC adaptor directly to the player’sDC IN terminal.SPEAKERHAUTPARLEURCOMPONENT VIDEO OUT S VIDEOOUT(480P/480I)Y PB PRSUBWOOFER CENTER SORROUNDAUDIO OUT VIDEOOUT5.1ch2ch (MIX)FRONTR L R LR 4≠L+-+-SPEAKERHAUTPARLEUR4≠Push the levers and insert the wires.Light grayNo lineBlack lineDark grayDC IN 9VËDC IN 9V12DC INDC IN4 Attach to cradle.(When the unit is off)Make sure built-in batteryis attached.≥To conserve powerWhen the unit is not going to be used for a longtime, disconnect the AC power supply cord fromthe AC outlet.The unit consumes a small amount of power(approx. 0.9 W, when in the multi cradle) whenin standby mode.∫ To detach(When the unit is off)Pull the lever so the unit lifts off the cradle.Multi cradle (AC adaptor)CautionUse the speakers only withthe recommended system.Failure to do so may lead todamage to the connectedequipment and/or thespeakers, and may result inthe risk of fire. Consult aqualified service person ifdamage has occurred or ifyou experience a suddenchange in performance.RELEASEVIDEO AUDIOOPT OUTSD CARD : PUSH RELEASE