2RQT9075-If you see this symbol-CAUTION!THIS PRODUCT UTILIZES A LASER.USE OF CONTROLS OR ADJUSTMENTS ORPERFORMANCE OF PROCEDURES OTHER THAN THOSESPECIFIED HEREIN MAY RESULT IN HAZARDOUSRADIATION EXPOSURE.DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF.REFER SERVICING TO QUALIFIED PERSONNEL.WARNING:TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK ORPRODUCT DAMAGE,≥DO NOT EXPOSE THIS APPARATUS TO RAIN, MOISTURE,DRIPPING OR SPLASHING AND THAT NO OBJECTSFILLED WITH LIQUIDS, SUCH AS VASES, SHALL BEPLACED ON THE APPARATUS.≥USE ONLY THE RECOMMENDED ACCESSORIES.≥DO NOT REMOVE THE COVER (OR BACK); THERE ARENO USER SERVICEABLE PARTS INSIDE. REFERSERVICING TO QUALIFIED SERVICE PERSONNEL.CAUTION!≥DO NOT INSTALL OR PLACE THIS UNIT IN A BOOKCASE,BUILT-IN CABINET OR IN ANOTHER CONFINED SPACE.ENSURE THE UNIT IS WELL VENTILATED. TO PREVENTRISK OF ELECTRIC SHOCK OR FIRE HAZARD DUE TOOVERHEATING, ENSURE THAT CURTAINS AND ANYOTHER MATERIALS DO NOT OBSTRUCT THEVENTILATION VENTS.≥DO NOT OBSTRUCT THE UNIT’S VENTILATION OPENINGSWITH NEWSPAPERS, TABLECLOTHS, CURTAINS, ANDSIMILAR ITEMS.≥DO NOT PLACE SOURCES OF NAKED FLAMES, SUCH ASLIGHTED CANDLES, ON THE UNIT.≥DISPOSE OF BATTERIES IN AN ENVIRONMENTALLYFRIENDLY MANNER.CAUTIONDanger of explosion if battery is incorrectly replaced. Replaceonly with the same or equivalent type recommended by themanufacturer. Dispose of used batteries according to themanufacturer’s instructions.[For]Australia]and]N.Z.]THIS UNIT IS INTENDED FOR USE IN MODERATE CLIMATES.[For]Asia]and]Middle]East]THIS UNIT IS INTENDED FOR USE IN TROPICAL CLIMATES.This product may receive radio interference caused by mobiletelephones during use. If such interference is apparent, pleaseincrease separation between the product and the mobiletelephone.The socket outlet shall be installed near the equipment andeasily accessible.The mains plug of the power supply cord shall remain readilyoperable.To completely disconnect this apparatus from the AC Mains,disconnect the power supply cord plug from AC receptacle.CLASS 1LASER PRODUCT(Inside of product)Caution for AC Mains Lead(For Saudi Arabia)For your safety, please read the following text carefully.This appliance is supplied with a moulded three pin mains plug foryour safety and convenience.A 5-ampere fuse is fitted in this plug.Should the fuse need to be replaced please ensure that thereplacement fuse has a rating of 5-ampere and that it is approvedby ASTA or BSI to BS1362.Check for the ASTA mark Ï or the BSI mark Ì on the body of thefuse.If the plug contains a removable fuse cover you must ensure that itis refitted when the fuse is replaced.If you lose the fuse cover the plug must not be used until areplacement cover is obtained.A replacement fuse cover can be purchased from your localdealer.CAUTION!IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THESOCKET OUTLET IN YOUR HOME THEN THE FUSESHOULD BE REMOVED AND THE PLUG CUT OFF ANDDISPOSED OF SAFELY.THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IFTHE CUT OFF PLUG IS INSERTED INTO ANY 13-AMPERESOCKET.If a new plug is to be fitted please observe the wiring code asstated below.If in any doubt please consult a qualified electrician.IMPORTANTThe wires in this mains lead are coloured in accordance with thefollowing code:Blue: Neutral, Brown: Live.As these colours may not correspond with the coloured markingsidentifying the terminals in your plug, proceed as follows:The wire which is coloured Blue must be connected to the terminalwhich is marked with the letter N or coloured Black or Blue.The wire which is coloured Brown must be connected to theterminal which is marked with the letter L or coloured Brown or Red.WARNING: DO NOT CONNECT EITHER WIRE TO THEEARTH TERMINAL WHICH IS MARKED WITH THELETTER E, BY THE EARTH SYMBOL Ó ORCOLOURED GREEN OR GREEN/YELLOW.THIS PLUG IS NOT WATERPROOF—KEEP DRY.Before useRemove the connector cover.How to replace the fuseThe location of the fuse differ according to the type of AC mainsplug (figures A and B). Confirm the AC mains plug fitted and followthe instructions below.Illustrations may differ from actual AC mains plug.1. Open the fuse cover with a screwdriver.2. Replace the fuse and close or attach the fuse cover.Information on Disposal in other Countries outside theEuropean UnionThis symbol is only valid in the European Union.If you wish to discard this product, please contact yourlocal authorities or dealer and ask for the correctmethod of disposal.Fuse coverFigure A Figure BFigure A Figure BFuse(5 ampere)Fuse(5 ampere)