90RQT8853Error MessagesOn the Unit’s Display PageH , F(“ ” stands for a servicenumber.)An error has occurred. The number following “H” or “F” dependson the status of the unit. Check the items below and in theTroubleshooting Guide. If the service number still does not disappearafter the check, reset the unit (¼ 78, “To restore the unit if it freezes”).−If the service numbers fail to clear, note the service numbers andcontact a qualified service person.−RC (“ ” stands for a number.) The remote control and the main unit are using different codes.Change the code on the remote control.78HARD ERR(“HArd” and “Err” are alternatelydisplayed.)If there is no change after turning the unit on and off, consult thedealer where the unit was purchased.−NO READ(“NO” and “REAd” are alternatelydisplayed.)The disc is dirty or badly scratched. The unit cannot record, play, or edit. 73The disc may be incompatible or of poor quality. 74 to 76You have used a lens cleaner and it has finished operation. Press[ OPEN/CLOSE] on the main unit to eject the disc.72Displayed when the unit is started. This is not a malfunction. −The unit is carrying out its recovery process. You cannot operate theunit while “ ” is displayed.−FULL There are already 16 scheduled recording programs. Deleteunnecessary scheduled recording programs.18UNSUPPORT(“UNSUP” and “POrt” arealternately displayed.)You have inserted a disc the unit cannot play or record on. 74, 75UNFORMAT(“UNFOr” and “MAt” arealternately displayed.)You have inserted a new DVD-RW/+RW or a DVD-RAM/DVD-RW(DVD-Video format) recorded on other equipment.You can format the disc when the format confirmation screen is displayed.15, 45“ ” is displayed on theunit’s display.This unit is confirming that it is connected with equipmentcompatible with HDAVI Control.−F74 The HDMI connection could not be authenticated due to a transfermalfunction. Consult the dealer where the unit was purchased.−F75 The HDMI connection could not be authenticated due to an internaldata malfunction. Consult the dealer where the unit was purchased.−U59 The unit is very warm.The unit switches to standby for safety reasons. Wait for about30 minutes until the message disappears.Reinstall the unit in an area with adequate ventilation. Do not blockthe cooling fan on the rear of the unit.−U61 There was a power failure or the AC power supply cord wasdisconnected while the unit was on. The unit is carrying out itsrecovery process. This process restores the unit to normal operation.The unit is not broken. Wait until the message disappears.−U72U73The HDMI connection acts unusually.–The connected equipment is not HDMI compatible.–The HDMI cable is too long. Please use a cable 5.0 meters (16.4 ft.) or less.–The HDMI cable is damaged.−U76 HDMI cannot be output because you are connected to a model thatdoes not support copyright protection.−U88 There was something unusual detected with the disc while recording,playing or copying; there was a power failure or the AC power supplycord was disconnected while the unit was on. The unit is carryingout its recovery process. This process restores the unit to normaloperation. The unit is not broken. Wait until the message disappears.80U99 The unit fails to operate properly. Press [/I POWER] on the mainunit to switch the unit to standby. Press [/I POWER] on the mainunit again to turn the unit on.−