90RQT9135Software UpdateSoftware of this unit can be updated automatically by followingmethod.≥From broadcasts≥From Internet [network connection and setting is required. (➡ 94)]Update of the software is done when it is in standby mode.Once the new software is found, it will start the download of thesoftware, and then the upload.Download of the software will start automatically when the power ofthis unit is turned off or when it is 3 a.m.≥The time it takes to update depends on the connection.– For Broadcast: About 2 to 4 hours– For Internet: About 1 hour(It may take longer than specified above to download becausethe download time differs depending on the network environment.It is recommended to be used in a broadband environment.)If you do not want to perform the software update during the standbymode, set the “Software Update in Standby” in the Setup menu to“Off”. (➡ 86)∫ If a software update is available, a notification isdisplayed.For broadcast≥Following screen is displayed when “Red” button is pressed.For Internet≥Update of the software will start when the power is turned off.∫ The unit’s display during the update≥“SW-DL” : Software is downloading.Download will stop when the power is turned on, orthe timer recording starts.≥“START”§ : Update of the software will start once the downloadis completed.≥“UPD /”§ : Software is updating.≥“FINISH” : Updated of the software has completed.§ You cannot operate the unit until the update is complete.Removing the AC mains lead while the update is in progressmay damage the unit.[Note]≥If the timer recording is scheduled within the following time at thestart of the download, the download will not be executed.– For broadcast: Within 4 hours– For Internet: Within 1 hour≥If downloading on this unit fails or this unit is not connected to theInternet, then you can download the latest software from thefollowing website and burn it to a CD-R to update the software.http://panasonic.net/support/1 TEN HD All DVB Services10:30Select FAV ListCorontation street9:00 - 11:00 NowRating:PG Bad Signal STTL TEXTSoftware updateSoftware update