Before using18LSQT0862Inserting/removing a cassette1 Slide the [OPEN/EJECT] lever and open thecassette cover.≥When the cover is fully opened, the cassetteholder will come out.2 After the cassette holder is opened, insert/remove the cassette.≥When inserting a cassette, orient it as shownin the figure, and then securely insert it as faras it goes.≥When removing, pull it straight out.3 Push the [PUSH] mark 1 in order to closethe cassette holder.4 Only after the cassette holder is completelyhoused, close the cassette cover.≥After using, make sure to rewind the cassettecompletely, remove it, and put it in a case. Storethe case in an upright position. (-76-)≥When condensation is formed on the lens or themain unit of the Camcorder, even if nocondensation alarm is indicated, condensationmay have formed on the heads or the cassettetape. Do not open the cassette cover. (-73-)ª When the cassette holder does notcome out≥Close the cassette cover completely, and thenopen it again completely.≥Check if the battery has run down.ª When the cassette holder cannot behoused≥Set the [OFF/ON] switch to [OFF], then to [ON]again.≥Check if the battery has run down.ª Inserting/removing the cassette≥When the cassette holder is in motion, do nottouch anything except the [PUSH] mark.≥When inserting a previously recorded cassette,use the blank search function to find the positionwhere you want to continue recording. If youoverwrite-record on a previously recordedcassette, be sure to find the position where youwant to continue recording.≥Close the cassette cover tightly.≥When closing the cassette cover, do not getanything, such as a cable, caught in the cover.ª Accidental erasure preventionIf the accidental erasure prevention slider 1 of acassette is opened (slide in the direction of the[SAVE] arrow), the cassette cannot be recorded.When recording, close the accidental erasureprevention slider of the cassette (slide in thedirection of the [REC] arrow).OPEN/EJECTPUSH1R E CSAVE1
