293°xREC12ª To add Sound while RecordingWith the supplied MagicWire Remote Control with Narration Micconnected to the [REMOTE] Jack, you can add a narration whilerecording is in progress.While the [TALK] Button 2 is pressed, the [ ] Indication isdisplayed and the sound is recorded from [MIC] 1.≥While the [TALK] Button is pressed, the built-in microphone doesnot operate.≥We recommend to keep the distance of approximately 4 inches(10 cm) between the [MIC] and the mouth when recording.ª Self-RecordingBy opening the LCD Monitor and turning it so that it faces forward (tothe lens side), you can let the subject in front of the Palmcordermonitor the shot while shooting is in progress.≥When the LCD Monitor is opened, the Viewfinder is disabledautomatically. However, when the LCD Monitor is rotated forward,the image is also shown in the Viewfinder.≥If you prefer to have the image on the LCD Monitor to look like animage in a mirror, set [SELF REC] on the [OTHER FUNCTIONS1]Sub-Menu to [MIRROR]. (Mirror Mode) Images are recordednormally and no left and right reversal occurs.≥If [MIRROR] is used during self-recording, only the basicindications, such as the Recording Indication [ ] (Red) or [¥],Recording Pause Indication [ ] (Cyan) or [¥;] and RemainingBattery Power Indication [x], are displayed. 3≥If a general Warning/Alarm Indication [°] appears, return the LCDMonitor to the original position in order to check the specificcontent of the Warning/Alarm Indication.~~~~~~~~~~~~~~~~~~~~~~Quick StartWhen this feature is activated, you can resume recording quicklyeven if the Palmcorder goes into standby mode (when left in Pausemode for 5 minutes with the Quick Start Recording Lamp on).Palmcorder will be ready for shooting in approximately 1.7 secondswhen the Power switch is turned [OFF] and back to [ON] again. Toactivate this feature, press the [QUICK START] Button to turn on theQuick Start Lamp.1 Press the [QUICK START] Button.≥The Quick Start Recording Lamp lights up.2 Set the [OFF/ON/MODE] Selector to [OFF].≥The Quick Start Recording Lamp remains lit.3 Set the [OFF/ON/MODE] Selector to [ON].≥The Palmcorder will be ready for recording in approximately1.7 seconds.To Cancel the Quick StartKeep the [QUICK START] Button pressed for approximately2 seconds and make sure the Quick Start Recording Lamp is not lit.≥For other notes, see page 86.12, 3STARTQUICKOFFONMODE
