Panasonic ET-YFB100G Operating Instructions Manual

Contents

Panasonic ET-YFB100G Operating Instructions Manual Manual pdf 27 page image

On-screen menu navigationENGLISH - 27On-screen menu navigationNavigating through the menu■ Operating procedurebutton1) Press the button on thecontrol panel.z The main menu screen is displayed.PICTUREINPUT SELECTET-YFB100 DIGITAL INTERFACE BOXPOSITIONLANGUAGEOPTIONHDMI 1HDMI 2COMPUTER 1COMPUTER 2S-VIDEOVIDEOz When the interface box is connected to theDIGITAL LINK compatible projector andoperated by a remote control, the method todisplay the main menu screen varies dependingon the projector model.• When DIGITAL LINK is selected from themain menu of the projector• When the Digital Interface Box menu isselected from the network menu of theprojectorFor the operation procedures, refer to theOperating Instructions of the projector used.2) Press ▲▼ to select an item from themenu item.z The selected item is highlighted in yellow.z The sub-menu items of the selected main menuare displayed on the right side.+24PICTUREINPUT SELECTET-YFB100 DIGITAL INTERFACE BOXPOSITIONLANGUAGEOPTIONSYSTEM SELECTORCLAMP POSITIONDIGITAL CINEMA REALITYAUTO3) Press the button.z The sub-menu items become selectable.4) Press ▲▼ to select a sub-menu item,and press ◀▶ to change or adjustsettings.z For some items, press ◀▶ to display anindividual adjustment screen with a bar scale asshown in the following diagram.+24CLAMP POSITIONz If an item does not have any further informationbut only an item name, pressing the button displays the next screen, and detailedsettings become possible.Notez When the button or the button is pressed when the menu screen isdisplayed, the screen returns to the previousscreen.z The remote control may not have the return button,depending on the DIGITAL LINK compatibleprojector model connected to the interface box.z Some items cannot be adjusted and some functionscannot be used depending on the signal to be inputto the interface box. The menu items that cannot beadjusted or used are shown in gray characters, andthey cannot be selected.z Some items can be adjusted even if signals are notinput.z Individual adjustment screen is clearedautomatically if no operation is performed forapproximately five seconds.z For menu items, refer to “Main menu” ( page 28) or“Sub-menu” ( page 28).z When 3D signals are input, the interface box menuis not displayed. To change the setting of theinterface box, input the 2D signal or operate withoutinputting any signal.z When 3D signals are input, all setting items of theinterface box are disabled.z The cursor color depends on the [OSD DESIGN]( page 36) settings on the menu. The selected itemis displayed with the yellow cursor by default.■ To reset adjustment values to thefactory defaultIf the default button on the remote control ispressed, the values set and adjusted in the sub-menu items will be restored to the factory defaultsettings.Press the default button on the remotecontrol.z The operation varies depending on thedisplayed screen.• When the sub-menu screen is displayedThe displayed sub-menu items are restoredto the factory default settings.• When the individual adjustment screen isdisplayedOnly items during adjustment are restored tothe factory default settings.+24CLAMP POSITIONThe on-screen menu (Menu) is used to perform various settings and adjustments of the interface box.