Panasonic ET-YFB100G Operating Instructions Manual

Contents

Panasonic ET-YFB100G Operating Instructions Manual Manual pdf 49 page image

Technical informationENGLISH - 49Mode Signal namedisplayResolution(Dots)Scanningfrequency Dot clockFrequency(MHz)Format *1Plug and playcompatibleHorizontal(kHz)Vertical(Hz)COMPUTER1/2HDMI1/2SXGA SXGA60 1 280 x 1 024 64.0 60.0 108.0 R/H 3 3SXGA75 1 280 x 1 024 80.0 75.0 135.0 R/H 3 3SXGA85 1 280 x 1 024 91.1 85.0 157.5 R/H ― ―SXGA+ SXGA+60 1 400 x 1 050 65.2 60.0 122.6 R/H ― ―SXGA+60 1 400 x 1 050 65.3 60.0 121.8 R/H 3 3SXGA+75 1 400 x 1 050 82.2 75.0 155.9 R/H ― ―WXGA+ WXGA+60 1 440 x 900 55.9 59.9 106.5 R/H ― ―UXGA UXGA60 1 600 x 1 200 75.0 60.0 162.0 R/H 3 3WSXGA+ WSXGA+60 1 680 x 1 050 65.3 60.0 146.3 R/H ― ―1920 x 1080 1920x1080/60 1 920 x 1 080 *2 66.6 59.9 138.5 R/H ― ―WUXGA WUXGA60RB 1 920 x 1 200 *2 74.0 60.0 154.0 R/H 3 3*1: Signals that show formats are as follows.V: VideoS: S-videoR: RGBY: YCB C R /YPBPRH: HDMI*2: VESA CVT-RB (Reduced Blanking) compatible.Notez The “i” at the end of the resolution indicates an interlaced signal.z When interlaced signals are connected, flickering may occur on the projected image.Corresponding 3D signals listThe 3D signals corresponding to the interface box are the HDMI signals in the following table.z When the 3D signal is input while a projector that does not correspond to the 3D is connected, the icon thatindicates the 3D image can not be output is displayed, and the image disappears. In this case, change theinput signal to the 2D.ModeFormat of the 3D image signalFrame packing Side by side Top and bottom750 (720)/60p 3*1 3 3*1750 (720)/50p 3*1 3 3*11125 (1080)/60i — 3*1 —1125 (1080)/50i — 3*1 —1125 (1080)/24p 3*1 3 3*11125 (1080)/60p — 3 31125 (1080)/50p — 3 3*1: HDMI standard 3D Mandatory format signal.