Panasonic ET-YFB100G Operating Instructions Manual

Contents

Panasonic ET-YFB100G Operating Instructions Manual Manual pdf 32 page image

[POSITION] menu32 - ENGLISHSelect [POSITION] from the main menu, andselect the item from the sub-menu.Refer to “Navigating through the menu”( page 27) for the operation of the menuscreen.[SHIFT]You can move the image position vertically orhorizontally if the image position projected on thescreen is shifted even when the relative position of theprojector and the screen is installed correctly.1) Press ▲▼ to select [SHIFT].2) Press the button.z The [SHIFT] individual adjustment screen isdisplayed.3) Press ▲▼◀▶ to adjust the position.■ For vertical (up and down)adjustmentOperation AdjustmentPress ▲ .The pictureposition movesup.Press ▼ .The pictureposition movesdown.■ For horizontal (right and left)adjustmentOperation AdjustmentPress ▶ .The pictureposition moves tothe right.Press ◀ .The pictureposition moves tothe left.[CLOCK PHASE]You can adjust to achieve an optimal image whenthere is a flickering image or smeared outlines.1) Press ▲▼ to select [CLOCK PHASE].2) Press ◀▶ or the button.z The [CLOCK PHASE] individual adjustmentscreen is displayed.3) Press ◀▶ to adjust.z Adjustment value will change between 0 and+31. Adjust so that the amount of interferenceis at a minimum.Notez Optimal value may not be achieved if the outputfrom the input computer is unstable.z When dot clock frequency of projecting signals is162 MHz or higher, noise may not be eliminatedeven if [CLOCK PHASE] is adjusted.z Adjustment is disabled when the component(YCBCR) signal of 525i (480i), or 625i (576i) is input.z Adjustment is disabled while the computer (RGB)signal of 525i (480i), or 625i (576i) is input.z Adjustment is disabled when a digital signal isinput.[OVER SCAN]zSupported only when S-VIDEO/VIDEO/YC B C R /YPB PR/RGB (movie)/DVI (movie)/HDMI (movie) signal is inputAdjusts the screen when characters or images at fouredges of the screen are not completely displayed.1) Press ▲▼ to select [OVER SCAN].2) Press ◀▶ or the button.z The [OVER SCAN] individual adjustmentscreen is displayed.3) Press ◀▶ to adjust.z Adjustment value is from 0 to +10.[POSITION] menu