Panasonic GP-VD151 Operating Instructions Manual

Also see for GP-VD150: Operating instructions Brochure & specs

Contents

Panasonic GP-VD151 Operating Instructions Manual Manual pdf 5 page image

4 (E)How to turn the power on and offww Turning the power onWhen supplying power to turn on the unit1 Set all the power switches of the units anddevices connected in the system to ON.2 Supply power to the unit.wp This unit does not have a power switch.When power is supplied to it, the status display lampwill light up orange.What happens next is that the initial operations areperformed, and when they have been completed, thePOWER ON mode is established, images are outputand control becomes possible.When the POWER ON mode is established, thestatus display lamp will light up green.wp It takes about 30 seconds per unit for the initialsettings operation to be completed. During thisperiod, the unit cannot be operated.(Status display lamp: light up orange)wp When operation is transferred to the STANDBYmode: The current pan-tilt position is stored in thememory (as a POWER ON preset), and the cameramoves so that it points toward the back.wp When operation is transferred to the POWER ONmode: The camera moves to the position which wasstored in the memory (as a POWER ON preset)when operation was transferred to the STANDBYmode.NotesWhen turning on the supply of power to the unitfrom the STANDBY mode1 Check that the unit is in the STANDBY mode.wp Check that the STANDBY mode has beenestablished (the status display lamp is lit in orange).2 Press one of the [CAM1] to [CAM2] buttonson the wireless remote controller to select theunit.3 Press the [ON/STANDBY] button on thewireless remote controller for at least2 seconds.The POWER ON mode is established, images areoutput, and control can be exercised.wp The unit’s status display lamp now lights up green.wp When operation is transferred to the POWER ONmode: The camera moves to the position which wasstored in the memory (as a POWER ON preset)when operation was transferred to the STANDBYmode.Note4 If a multiple number of units are going to beused, repeat steps 2 and 3 as required.The unit’s status display lamp blinks green when a signalmatched by the remote control ID has been received, andit blinks orange when a signal that is not matched by theremote control ID has been received.ENGLISH