134Chapter 77.1 Error Indication ListDisplay scale error.This error occurs if thesame distance ordisplayed value isentered for the firstand second points. Ora value beyond therange is entered or theinclination is too large.AlarmoutputEEPROM dataloading errorTurn the power off thenon again. If the errorpersists, initialize settings(to restore factoryshipment settings) andenter settings again.After resetting, initializesettings and enter settingagain.Check the wiring andconnect again.Check the wiring andconnect again.Perform adjustment again.Perform adjustment again.EEPROM datawriting errorBroken sensor headcableThree-point calibrationis incorrect.The correction dataafter three-pointcalibration is incorrect.There is a short circuitin external outputcircuit.Memory switchingerrorONONONONONError indication Description of error RemedyLower lineUpper linePress .Press .Press .Press .Press .Press .Press .Automatic recoveryAutomatic recoveryEnter correct values.Enter correct values.Enter the correct scale.Distance setting range:0mm to 110% of F.S.The following equationof the upper and lowerlimit values standstrue:[(Upper limit value)- (hysteresis width)] <[(Lower limit value) +(hysteresis width)]The following equationof the hysteresis widthstands true:[(Upperlimit value) -(hysteresis width)] <[(Lower limit value) +(hysteresis width)]Resetting keyPress and hold.Or enter an externalreset signal.Press and hold.Or enter an externalreset signal.Enter correct values.Setting range:0mm to 120% of F.S.Enter the correct value.Setting range:0mm to 110% of F.S.The trigger levelexceeds the settingrange.The sum of the triggerlevel and triggerhysteresis exceedsthe setting range.Short circuitprotection functions.
