3-43.1.2 Restriction According to Mounting DirectionsIf the unit is being installed in a horizontal orientation, or our Programmer II and C-NET adaptor arebeing connected to the TOOL port, note that the ambient usage temperature should be as below.Modelname Condition AmbienttemperatureGT11Vertically installedProgrammger IIC-NET adapter 0 to 45 CGT21Horizontally installedProgrammer IIC-NET adapterGT32 Horizontally installed 0 to 40 CGT32-E Horizontally installed -20 to 55 CNote) When installing the unit aslant, the restriction is the same as the one when installing horizontally.3.1.3 Installation SpaceApplicable panel thicknessA panel with a thickness of 1.0 to 5.0 mm should be used.Clearance when the GT is installedWhen installing the GT unit, if other parts are being installed to the panel or cables are being wired to it,we recommend providing a clearance around the GT unit. This prevents cables from being damaged,and facilitates the installation work. Also, make sure that the slits in the main unit are never obstructed.Model name ClearanceClearance on the surfaceto connect the screentransfer cableClearance on themounting surface whenusing a SD memory cardGT0130 mm or more(50 mm or morerecommended)20 mm -GT11GT21GT02L 60 mm -GT0260 mm 40 mm or moreGT05GT12GT32GT32-E* It should be 40 mm or more when using a SD memory card.3.1.4 UL/c-UL QualificationBe aware of the following when applying for UL standard for the equipment that the GT has beenbuilt in. When the GT built in equipment, the GT should meet the standard as a part of the enclosure. As the rear of the GT is not qualified as an enclosure, provide a fire enclosure (metal barrier) thatentirely covers the rear and lateral sides of the GT.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
