- 126 -To use the Wi-Fi function, connect this unit to a wireless access point or smartphone via Wi-Fi.∫ About the status indicator and the connection status icon whenconnected to Wi-FiConnecting to a wireless access pointCheck if the wireless access point you are using is compatible with WPSj If the wireless access point is compatible with WPS:Proceed to the following [Easy Connection (WPS)]j If the wireless access point is not compatible with WPS:[Manual Connection] (l 128)≥ WPS is an abbreviation for Wi-Fi Protected Setup™∫ If this is the first time the Wi-Fi button is pressed1 Press Wi-Fi button.2 Touch [YES].3 Touch [Easy Connection (WPS)].4 Set the wireless access point to waiting for WPS.≥ For further details, please read the operating instructions for thewireless access point.≥ A message is displayed when the connection is complete.≥ A message is displayed when the connection attempt fails. Touch[EXIT], and set the connection again.Wi-Fi [HC-V520]/[HC-V520M]Connecting to Wi-FiIf the clock has been set for the first time, the confirmation message for the Wi-Fi settings will bedisplayed. Touch [YES], and then configure the access point settings below.A Lit green≥ The status indicator is lit green while this unit is connectedto a destination device after completing a Wi-Fi connection.≥ When Wi-Fi is disconnected, the status indicator is litred again.B The connection status iconWhen connected to wireless access point:connected to Wi-Fi/ not connected to Wi-Fi≥ The display will change as follows according to theradio wave intensity: # # # .When directly connected:connected to Wi-Fi/ not connected to Wi-Fi[Easy Connection (WPS)]