- 34 -This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.≥ When in Quick Start Standby Mode about 70% of the power used in recording pause modeis being consumed, so the recording time will be reduced.≥ /Quick Start will not work if there is no SD card inserted.≥Quick Start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there is noSD card inserted.1 Select the menu.2 Close the LCD monitor.The status indicator A flashes green and the unit goes intoQuick Start Standby Mode.≥ The lens cover does not close.3 Open the LCD monitor.The status indicator A lights red and the unit is putinto recording pause.≥ Quick Start Standby Mode is canceled ifj about 5 minutes elapsedj mode is set to≥ Depending on the recording conditions and menu settings, time for Quick Start may be longerthan 0.6 seconds.≥ It may take some time for Automatic White Balance to adjust.≥ In the Quick Start Mode, the zoom magnification becomes approx. 1k.≥ When it has gone into Quick Start Standby Mode automatically with the [ECONOMY (BATT)](l 33)/[ECONOMY (AC)] (l 33), close the LCD monitor once and open it again.≥ Turn the unit off using the power button.Touch screen operation, starting and stopping of recording and unit on/off can be confirmed with thissound.When [OFF] is selected, the sound is not output at the start/end of recording, etc.2 Beeps for 4 timesWhen an error occurs. Check the sentence displayed on the screen. (l 171)[QUICK START]: [SETUP] # [QUICK START] # [ON][ALERT SOUND]: [SETUP] # [ALERT SOUND] # desired setting(Volume low)/ (Volume high)/[OFF]HC-V520 HC-V510HC-V520MMENUMENU
