Panasonic KT9 Instruction Manual

Also see for KT9: Instruction manual

Contents

Panasonic KT9 Instruction Manual Manual pdf 19 page image

19[Auto-reset]• If auto-reset “Perform” is selected and the key is pressed,the AT indicator flashes and the unit reverts to the PV/SV displaymode.• If auto-reset is performed, offset correction immediately starts.• To prevent key misoperation, other settings cannot be performed for 4minutes after auto-reset starts.• After auto-reset is completed, the AT indicator is turned off and thereset value is automatically set.OUT1 proportional band setting 10• Sets OUT1 proportional band.The control action becomes ON/OFF action when set to 0 or 0.0.• Setting range: 0 to 1000 (0 to 2000 )With a decimal point, 0.0 to 999.9 ( ), DC input: 0.0 to 100.0%[Percentage of the scaling span (scaling high limit-scaling low limit)]OUT2 proportional band setting 1.0 times• Sets OUT2 proportional band.OUT2 becomes ON/OFF action when set to 0.0.• Available only when Heating/Cooling control (option) is added.• Setting range: 0.0 to 10.0 (multiplying factor to OUT1 proportionalband)Integral time setting 200 seconds• Sets the integral time.Setting the value to 0 disables the function (PD action).• Setting range: 0 to 1000 secondsDerivative time setting 50 seconds• Sets the derivative time.Setting the value to 0 disables the function (PI action).• Setting range: 0 to 300 secondsARW (Anti-reset windup) setting 50%• Sets the anti-reset windup.• Available only for PID action.• Setting range: 0 to 100%OUT1 proportional cycle setting• Sets OUT1 proportional cycle.Relay contact output: 30secNon-contact voltage output: 3secNot available for ON/OFF action and DC current output type• With the relay contact output type, if the proportional cycle timeis decreased, the frequency of the relay action increases andthe life of the relay contact is shortened.• Setting range: 1 to 120 secondsOUT2 proportional cycle setting• Sets OUT2 proportional cycle.Relay contact output: 30secNon-contact voltage output: 3secNot available for ON/OFF action and DC current output type• Available only when Heating/Cooling control (option) is added.• Setting range: 1 to 120 seconds