KW8M Eco-POWER METER12Chapter 4 Settings4.1 Operation procedure【Basic setting to measure】When wiring Eco-POWER METER and CT and setting mode 1 after power on, Eco-POWER Meter canmeasure the electric power. In order to use the other functions, set mode2, 3 and 4 according to youruse. *For AKW8111H, be sure to set calendar timer (Mode 5) and initialize memory of main unit(Mode 4) before measuring.Mode 1…Mode for setting each parameter for power measurementMonitor (Display when power on)Setting mode(Mode 1) (Mode 2) (Mode 3) (Mode 4) (Mode 4) ＊1 Phase/Wire system setting modeSYST Refer to the next page.CT type setting modeCT-T When select“5A”Primary side current ofCT setting modeCT-1When selectother than “5A”Voltage range setting modeVOLT VT setting modeVTCurrent for timemeasurement setting modeHM-ACutoff current setting modeCUTAUnit for pulse output setting modePL-PWhen select“Values”When select “AL-P”When select “AL-C”When select “AL-S”When select “Cnt”or “DEM”Power alarm settingmodeAL-PCurrent alarm settingmodeAL-CStand-by alarm settingmode 1ALS1Preset value settingmodeCnt Stand-by alarm settingmode 2ALS2Demand alarm setting mode *1DEM1/DEM2/DEM3 Electricity rate setting modeRATE Press to return Monitor.Monitor *1 Only for AKW8111H. It is not displayed for AKW8111.
