KW8M Eco-POWER METER38・Current measurement partsEco-POWER METER measures the current as below.DisplaySystem L1 (CT1) L2 (CT2) L3 (CT3)Single-phase two-wire L1-phase current - -Single-phase three-wire L1(R)-phase current L2 (S)-phase current -Three-phase three-wire L1(R)-phase current L2 (T)-phase current -Three-phase four-wire L1(R)-phase current L2 (S)-phase current L3 (T)-phase current6.2.4 Voltage・It displays the voltage value of the load.・Press ▽> to change voltage between P1 and P0, P2 and P0, P3 and P0.*Before start measuring, select phase and wire system according to the measured load.When Single-phase 3-wire or Three-phase 3-wire is selected, it doesn’t measure Single-phase2-wire system correctly. When Three-phase 4-wire system is selected, it doesn’t measureSingle-phase 2-wire, Single-phase 3-wire, Three-phase 3-wire system correctly.Select phase and wire system according to the measured system.(Refer to the explanation of setting mode.)[V]Lighting・When input voltage is under 10.0V at 200V range, and when input voltage is under 20.0V at 400Vrange, it displays “0.0” and doesn’t measure.・When input voltage exceeds 150%F.S. at each range, 「 」 will be displayed.・Voltage measurement partsEco-POWER METER measures the voltage as below.DisplaySystem L1V L2V L3VSingle-phase two-wire Voltagebetween P1 and P0 --- ---Single-phase three-wire Voltagebetween P1 and P0Voltagebetween P2 and P0 ---Three-phase three-wire Voltagebetween P1 and P0Voltagebetween P2 and P0 ---Three-phase four-wire Voltagebetween P1 and P0Voltagebetween P2 and P0Voltagebetween P3 and P0
