Installation/Registering the RepeaterOnce the repeater is connected to an AC outlet, it automatically goes into registration mode (if notalready registered).IMPORTANTR Before registering the repeater to the base unit, you must turn the repeater mode on. Refer to theappropriate documentation for the base unit.R If the repeater is already registered, deregister the repeater first, then re-register it. For registering andderegistering the repeater, refer to "Deregister" and "Re-register" in "Troubleshooting".NoteR Use only the supplied Panasonic AC adaptor.R When connecting the AC adaptor to the repeater, press the plug firmly into the repeater for secureconnection.1 Repeater: Connect the AC adaptor.2 Base unit: Press and hold the Handset locator button for about 4 seconds until the STATUSindicator flashes red.R The button and indicator depend on the base unit.R If all registered handsets start ringing, press the same button to stop. Then repeat this step.R The next step must be completed within 90 seconds.3 Repeater: Connect the AC adaptor to an AC outlet.R When the repeater is turned on, the STATUS indicator and RSSI/ID indicator turn amber for about2 seconds.4 Repeater: Wait until the STATUS indicator and RSSI/ID indicator turn green. (The repeater isready for use.)R If the indicators do not turn green, re-position the repeater in a place where the indicators turngreen.5 Base unit: To exit registration mode, press the Handset locator button.R The button depends on the base unit.232. Linking to SIP Cordless Phones