Panasonic KX-CL500 Setup Manual

Also see for Jetwriter KX-CL500: Specifications Operating instructions User guide

Setup29Turn the printer on, then the computer.The READY indicator on the printer starts blinking.After approximately 30 seconds [Standard Memorywithout the printerís hard disk drive at 20∞C (68∞F) /65%RH / 120V], ìReadyî is displayed on the printer LCDpanel.NOTE:• If the Self Calibration is done, it will take much time.• When the printer enters the Power Save mode, thePOWER indicator will start blinking and ìPower Saveîwill be displayed on the printer LCD panel.• When you turn on the printer for the first time, it will takeabout 5 minutes to fill the printer with toner. When theprocess is completed, the printer's LCD will displayìReadyî.• Select English, German, French, Spanish or Italian asthe language which is to appear on the LCD panel.• English is the default language.1 Press MENU/EXIT (PAUSE) button to enter theMenu mode.2 Press (CONTINUE) or (CANCEL) button untilthe Other menu appears.3 Press ENTER button.Language item menu appears.4 Press ENTER button.English selection menu appears.5 Press (CONTINUE) or (CANCEL) button untilthe desired language is displayed.6 Press ENTER button to activate your selection.NOTE:• Adhere the enclosed ìSupplies Re-order Labelî near theprinterís LCD panel to assist you in interpreting thesupplies related messages that may appear on theprinterís LCD display.It is possible to confirm the printer's settings by printing aconfiguration page.1 Press MENU/EXIT (PAUSE) button to enter theMenu mode.2 Press (CONTINUE) button until Test Page menuappears.3 Press ENTER button.Menu Map item menu appears.4 Press (CONTINUE) button until ConfigurationPage item menu appears.5 Press ENTER button.The printer will start printing a configuration page.Power On Setting the LCD LanguagePrinting a Test Page fromthe Printer PanelSetup

/ 32

Related manuals for Panasonic Jetwriter KX-CL500