Automatic dialing mode settingl When the telephone line cord and the power cord are connected, the unit will automatically start to detectthe dialing mode of your telephone line.Display:Wait until one of the following messages is displayed.Your line has touch tone service.Your line has rotary pulse dial service.l If the power cord is disconnected or a power failure occurs, the unit will detect the dialing mode again whenpower is restored.l If you connect the power cord before connecting the telephone line cord, the following messages will beshown alternately.Connect the telephone line cord.INSERT TEL LINENO TEL LINELINE IS PULSELINE IS TONECHECKING LINEWall jack(RJ11C)120 V, 60 HzTelephoneline cordPower cordPower surgeprotector( )Line surgeprotector( )26Setup (Main Unit)Connections1 Connect the handset cord.2 Connect the telephone line cord.3 Connect the power cord.l The unit will automatically start todetect the dialing mode of yourtelephone line (see below).l When the power is turned on for thefirst time, the unit will print somebasic information.Note:l For additional equipment protection, we recommend the use of a surge protector. The following types areavailable; TELESPIKE BLOK MODEL TSB (TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPEMFG. CO.), SUPER MAX (PANAMAX) or MP1 (ITW LINX).The warranty does not cover damage due to power line surges or lightning.l When you operate this product, the power outlet should be near the product and easily accessible.
