3. Telephone441 Press {v} or {e}.2 Press {HOLD/CLEAR}.L To cancel erasing, press {<}, then{OFF}.3 Press {HOLD/CLEAR} again.Using the base unit1 Press {MENU} repeatedly to display“CALLER SETUP”.2 Press {SET}.3 Press {SET} again.L To cancel erasing, press {STOP}, then{MENU}.4 Press {SET}.5 Press {STOP}.3.11.2 Erasing specific callerinformationUsing the handsetMake sure the handset is not being used.1 Press {v} or {e} repeatedly to display thedesired item.2 Press {HOLD/CLEAR}.L To erase other items, repeat from step 1.3 Press {OFF}.Using the base unit1 Press {CALLER ID}.2 Press {A} or {B} repeatedly to display thedesired item.3 Press {ERASE}.L To erase other items, repeat steps 2 to 3.4 Press {STOP}.3.12 Storing callerinformation into thenavigator directoryImportant:L This feature is not available in thefollowing cases.– The telephone number includes dataother than numbers (i.e., * or #).– The caller information does notinclude a telephone number.3.12.1 Into the handsetL Keep the front cover page open for buttonlocations.Make sure the handset is not being used.1 Press {v} or {e} repeatedly to display thedesired item.L If the number requires editing, press theright soft key ({EDIT}) (page 42).2 Press {>}.L To stop storing, press {<}.3 Press {>} again.L To continue storing other items, repeatfrom step 1.L To exit the programming mode, press{OFF}.If there is no name information for thecaller, “Enter name” will be displayed.1. If a name is not required, press {v}. If aname is required, enter the name (page36). When finished, press {v}.2. Press the right soft key ({SAVE}).L To continue storing other items,repeat from step 1.L To exit the programming mode, press{OFF}.3.12.2 Into the base unitL Keep the front cover page open for buttonlocations.1 Press {CALLER ID}.2 Press {A} or {B} repeatedly to display thedesired item.Example:S A V EExample:
