Panasonic KX-NT700 Operating Instructions Manual

Also see for VoiceSonic KX-NT700: Specifications Quick reference guide Operating instructions Quick reference guide Operating instructions

Contents

Panasonic KX-NT700 Operating Instructions Manual Manual pdf 35 page image

• You can switch between numeric and alphabetentry modes by pressingCHAR , and changebetween uppercase and lowercase characterentry by pressing [ ]. See page 62 forinformation on entering characters.• A period can be entered by pressing [1], whenthe character entry mode is alphabet entrymode.• If you make a mistake, press [ ], then enterthe correct SIP extension number or SIP URI.To erase all numbers, press and hold [ ].3. Press [ ] or .4. To end the call, press [ ].Adjusting the Speaker VolumeWhile on a call, press [ ] or [ ] repeatedly to adjustthe speaker volume. There are 8 levels of volume.Quieter Louder• If the other party has difficulty hearing you, press[ ] to decrease the speaker volume. Your voiceheard by the other party will become louder.RedialingThe last 10 calls made are stored in the redial list, inorder of newest to oldest call.1. Press [REDIAL/PAUSE].• The last call made is displayed.2. Press [ ] or [ ] repeatedly to scroll through thelist.• To erase the displayed item, pressERASE .• To exit the redial list, press [MENU].3. When the desired entry is displayed, press [ ] or.Note• The line that was used to make each call in theredial list ("IP" or "TEL") is shown in thelower-right corner of the display. This line will beused when the call is redialed.Example:The TEL line willbe used whenyou redial thisnumber.• If the "Line Selection" setting is not set to"IP + TEL" (see page 33), TEL line callscannot be redialed.• If the dialed number contains too manycharacters, it cannot be redialed correctly. Themaximum for each type of number is as follows:– TEL line: 128 digits– IP line (SIP extension number): 32characters– IP line (SIP URI): 97 characters (excluding"sip:")Entering Dialing PausesA pause is sometimes required when making calls onthe TEL line using a PBX or a long distance service. Forexample, if you must dial "9" before dialing an outsidephone number, you probably wait (pause) after dialing"9" until you hear a dial tone.By pressing the [REDIAL/PAUSE] button when dialing,the unit will store the dialing pause along with the phonenumber in the redial list. If you make a call from theredial list later, the unit will dial the number wait for thepre-programmed number of seconds (default: 3 s; seepage 54) for each dialing pause you entered.Example:1. Press [9] (to access an outside line of a PBX).2. Press [REDIAL/PAUSE].• Press [REDIAL/PAUSE] repeatedly to createlonger pauses. An additional pause is insertedeach time [REDIAL/PAUSE] is pressed.3. Dial the phone number.4. Press [ ] or .Making a Call from the PhonebookSee page 40 to add entries to the phonebook.1. Press .2. Press [ ] or [ ] repeatedly to scroll through thephonebook entries.• Entries are displayed in the following orderwhen [ ] is pressed.Symbols®Numbers®LettersDocument Version 2011/06 Operating Instructions 35Making and Answering Calls