System Programming 4-43If the system is installed behind a host PBX, each outside (CO) line may require an accesscode to make an outside call. Up to 8 access codes can be stored for each outside line.When the programmed codes are dialed, the pause time assigned in program [417] “PauseTime” is automatically inserted, and toll restriction is applied after the code.*1 Outside (CO) line number: 1 through 6 / (All outside lines)*2 Insert a “,” for each code using the button on the overlay.Example:• Access codes 81, 82 on outside (CO) line number 1Default All outside (CO) lines – Not stored• To correct a wrong entry, press the CLEAR button and enter the new one.• Feature ReferenceSection 3, FeaturesHost PBX Access,Selects a pulse rate for each outside (CO) line which sets “Pulse Mode” or “Call blockMode” in program [401] “Dial Mode”. There are 2 pulse rates, Low Speed (10 pps) andHigh Speed (20 pps).* Outside (CO) line number: 1 through 6 / (All outside lines)Default All outside (CO) lines – Low Speed04[402] Pulse Speed Selection304[403] Host PBX Access CodesNEXT STORE ENDaccess code*2Up to 8 access codes1 or 2 digits(0···9)304 NEXT STORE END1 8 81 , 2(Low/HighSpeed)outside line no.*1To continue(1 ··· 6/ )(1 ··· 6/ )2 NEXT SELECT ENDoutside line no.*NEXT PREVorSELECTTo continueTo continueSTORENEXT PREVorTo continue!!+SELECT4.2 System Programming [402]-[403]
